Overview
The Artec Industries BR1052 is a shock tower with a frame cutout for mounting shocks, coilovers, air shocks or struts. It is CNC laser cut and bent from 1/4 in. steel, sold individually, and is a universal application part.
The tower sits 12 inches from the top of the frame and includes a reservoir pass-through hole for simpler routing. It requires welding and painting before use.
Key features
- CNC laser cut and bent from 1/4 in. steel
- 1/2 in. mounting hole for the shock
- Reservoir pass-through hole for simple routing
- Positioned 12 inches from the top of the frame
- Universal application
Frame mounting and welding
A shock tower carries the shock’s load into the frame, so its placement and weld quality decide how well the frame handles repeated compression. Choose a location with a clean, straight frame section and avoid heat near fuel lines, brake lines and wiring.
Lay out the tower and the reservoir routing before cutting, and check that the shock body and reservoir have clearance through full travel. Prep the frame by grinding paint and rust from the weld zone, and paint the finished tower to limit corrosion at the joints.
Frame gussets or doubler plates are often added at mounting points that see high loads, so consider them during planning. After the first few trips, inspect welds for cracking and check that bolts and shock hardware remain tight.
- Check reservoir clearance through full travel
- Grind paint and rust from the weld zone
- Inspect welds after rough off-road use
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | BR1052 |
| UPC | 816791020574 |
| Material | 1/4 in. steel |
| Mounting hole | 1/2 in. |
| Position | 12 inches from top of frame |
| Quantity | Sold individually |
| Finish | Not finished; painting required |
Vehicle fitment
It is a universal application part, so suitability depends on your frame layout, shock type and mounting height. Check these against your build before welding.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The tower is welded in place and then painted, so plan the frame cutout and the reservoir pass-through before welding. Weld by a qualified fabricator who can check the frame’s strength at the mounting point.
What’s included
One shock tower.
Not included: The shock, coilover, air shock or strut that mounts in the tower.













