Overview
The Fabtech K3044M is a multiple front shock system with Stealth Monotube Shocks for 2009–2013 Ram 2500 and Ram 3500 trucks. It comes with upper and lower mounts and all required hardware, and is built from 1.5 in. OD tubular components.
The system is a bolt-on, no-weld design with a 4 hour install time. It is intended to increase dampening capacity. Coverage for 2009–2010 and 2011–2013 models is shown below.
Key features
- Stealth Monotube Shocks included with the system
- Upper and lower mounts
- All required hardware
- 1.5 in. OD tubular construction
- Bolt-on, no-weld installation
- Designed to increase dampening capacity
Mount hardware and torque checks
Upper and lower mounts hold the shock in position under load, so their condition matters as much as the shock itself. Before installing, confirm each mount seats fully without forcing it, and that the bushings sit square in the bracket. A mount that goes in crooked can wear bushings quickly and change the shock angle.
Suspension fasteners should be torqued after the truck is back on the ground, then rechecked after the first drive. Thread locker is commonly used on bolts that work loose under vibration. Plan to inspect mounts at regular service intervals, especially after rough trail use or heavy towing.
- Seat each mount fully before tightening
- Torque fasteners with the truck at ride height
- Recheck hardware after the first drive
Specifications
| Brand | Fabtech |
|---|---|
| Part number | K3044M |
| UPC | 700007234191 |
| Position | Front |
| Shocks | Stealth Monotube |
| Mounts | Upper and lower |
| Hardware | All required hardware included |
| Tubing outside diameter | 1.5 in. |
| Installation | Bolt on, no weld, 4 hour install time |
Vehicle fitment
It fits 2009–2010 Dodge Ram 2500 and 3500 trucks and 2011–2013 Ram 2500 and 3500 trucks. Trims are grouped by model and year, from SLT and ST up to Power Wagon, TRX and Laramie Longhorn.
Trucks outside the Ram 2500 and 3500 lines, and earlier or later generations, are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a bolt-on, no-weld installation with a 4 hour install time, and the upper and lower mounts are included. Support the truck on stands before working at the front axle.
What’s included
Stealth Monotube Shocks, upper and lower mounts and all required hardware come in the kit. Lay out the packed parts before starting work.









