Overview
The Trail Gear 110164-1-KIT is a universal shock hoop kit that mounts on the frame side at the front of a vehicle to hold a shock. The hoops are made from 1035 DOM steel, precision CNC bent, and sized to accommodate 12-14 inch shocks.
The hoop accommodates both 14 inch and 12 inch shocks.
Key features
- Accommodates 12-14 inch shocks
- Precision CNC bent 1035 DOM steel hoops
- 16 inch vertical measure and 10 inch width
- 1.5 inch tube diameter with .120 wall
Measuring before you mount
A shock hoop holds the shock body at the frame, so its position controls shock angle, travel and clearance against the tire and steering components. Before cutting or drilling, mark the shock’s eye-to-eye length at full extension and full compression and compare it with the hoop’s accommodated range.
Fastener condition matters as much as steel strength. Check the mounting bolts and nuts after the first few trail runs, and look for cracked welds, elongated holes or paint chips that show movement at the hoop. Replace worn fasteners as a set rather than one at a time.
Plan for the shock’s bushing and clevis hardware to be replaced at the same service, since the same loads wear those parts.
- Measure extended and compressed shock length
- Inspect hoop welds and mounting holes for cracking
- Replace worn fasteners in matched sets
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 110164-1-KIT |
| UPC | 70000621497 |
| Material | 1035 DOM steel |
| Vertical measure | 16 inches |
| Width | 10 inches |
| Tube diameter | 1.5 inch |
| Tube wall thickness | .120 inch |
| Shock length accommodated | 12-14 inch |
| Mounting location | Frame side |
| Vehicle location | Front |
Vehicle fitment
Fitment is not tied to a vehicle year, make or model. It is a universal fit with frame side mounting at the front. Because hoop spacing depends on your shock and mount points, measure those before installing. Check fit against your year, model and trim before ordering.
Installation notes
Some modifications may be required during installation. Measure your shock first, since the hoop is designed around 12 to 14 inch lengths, and plan the mounting at the frame side of the front end.
What’s included
Hardware is not part of this kit, and the shocks must be sourced separately.








