Overview
The Artec Industries A/IBR1137 is a pair of rear lower control arm brackets with an integrated skid plate. They replace factory lower control arm brackets on a 3-1/2 inch axle tube, and they are welded to the axle. Factory brackets are made from sheet metal and often bend or tear away, so these are built from 1/4 inch thick boxed steel plate to hold up better under load.
The design wraps further around the axle tube than the factory bracket, giving more weld surface area. The skid plate sits under the cartridge joint to take direct impact. The bracket is shaped to look like a custom fabricated piece rather than angle iron or c-channel. Shock mounts sit at factory height and do not limit up-travel.
Key features
- Mounting width of 2.625 inch fits common cartridge joints such as Johnny, Flex and Ballistic, and factory control arm bushings.
- Integrated skid plate wraps the bottom of the bracket around the joint to protect it from direct impact.
- The skid plate does not restrict joint movement.
- Bracket wraps the axle tube further than the factory bracket, adding weld surface area against tearing off.
- Made from 1/4 inch thick boxed steel plate for strength and impact resistance.
- Shock mounts at factory height for a direct replacement layout.
- Provides mounting locations for lower control arms, shocks and a sway bar.
Before welding in new brackets
Welded control arm brackets carry the full load of the lower control arm, so weld quality matters as much as the bracket itself. Clean the axle tube down to bare metal where the bracket will sit, and check that the tube is round and undamaged before fitting.
Skid plates protect the cartridge joint, but they also add weight low on the axle. Check that the joint still moves freely after the brackets are in place, and confirm that the skid plate clears the ground and the exhaust at full suspension travel.
- Clean the axle tube to bare metal before welding
- Check that the tube is round and undamaged
- Confirm joint movement after installation
- Verify skid plate clearance at full travel
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | A/IBR1137 |
| Type | Control arm mount (lower control arm bracket) |
| Quantity | Pair |
| Tube diameter | 3-1/2 inch |
| Mounting width | 2.625 inch |
| Material | 1/4 inch thick boxed steel plate |
| Skid plate | Integrated, on bottom of bracket |
| Shock mount height | Factory height |
Vehicle fitment
These brackets are welded to a specific axle tube, so they are not a universal part. Confirm fit for your axle tube diameter, control arm setup and vehicle year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The brackets require welding to the axle and removal of the factory bracket. Use a competent welder, since incorrect installation or improper welding can cause the mount to fail.
What’s included
A pair of brackets with the integrated skid plates.
Not included: cartridge joints, bushings, shocks and the welding work needed to attach the brackets.










