Overview
The ARB RD169 is a rear Dana 60 air locking differential in the C clip version, with 35 splines and 4.10 down gearing. Air engages the selectable lock, changing an open differential into full spool operation for both wheels. No vehicles are named, so fitment depends on matching the axle.
C clip axles retain the axle shafts differently from other designs, so confirm that your axle uses C clips before selecting this locker. The 35 spline count and 4.10 down gearing are the other key matching details.
Key features
- Air engages the selectable locker
- Full spool operation for both wheels
- Built for 35 spline axles
- Listed gearing: 4.10 down
- Available in the C clip version
- Mounts on a rear axle
Retention and reassembly
C clip axles hold each shaft with a clip at the inner end of the axle, and the clip must sit fully seated to keep the shaft from walking out. When fitting a locker, inspect the clip groove and clip for wear, bending or cracks, and replace any part that is not in good shape. A loose or damaged clip can let the shaft move under load.
A rear locker changes how the axle loads the shafts, so bearings and seals see more torque when the lock is engaged. After the swap, drive slowly at first, check for noise or vibration, and look for fluid seepage at the axle seals.
- Check the C clip groove for wear
- Replace a clip that shows any bend
- Verify shaft seating before refilling fluid
- Inspect rear seals after the first trail run
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | RD169 |
| UPC | 9332018000538 |
| Differential type | Selectable locker |
| Axle manufacturer | Dana |
| Axle type | Dana 60 |
| Retention | C clip |
| Axle spline count | 35 splines |
| Gear ratio | 4.10 down |
| Axle location | Rear |
Vehicle fitment
Fit depends on a Dana 60 rear axle with C clip retention, 35 spline shafts and 4.10 down gearing.
Front axle applications and other spline counts are not covered by this part’s stated specifications. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The locker needs an air compressor and air supply in place before it can engage. Work on a rear axle should be done with the vehicle securely supported on stands, and the C clip retention should be checked during reassembly.
What’s included
Included: the RD169 air locking differential.
Not included: An onboard air compressor, which is needed to activate the locker.








