Overview
The ARB RD173 is a rear Dana 70/80 air locking differential with 35 splines and 4.10 down gearing. Its selectable air locker changes the open axle into a full spool, so both wheels turn with equal drive. No vehicles are named for this part, so the axle type and spline count do the matching.
The listed axle types are Dana 70 and Dana 80, so match the housing to one of those before fitting the RD173. The 4.10 down gearing is also a key check.
Key features
- Air activated selectable locker
- Full spool action for both wheels
- Fits Dana 70 or Dana 80 axles
- Built for 35 spline shafts
- Listed gearing: 4.10 down
- Rear axle location
Dana 70 and 80 housings
Dana 70 and Dana 80 axles are heavy-duty housings often found under larger trucks used for hard work. A selectable locker in this class puts more torque through the ring gear, pinion and axle shafts when both wheels are locked together. That load is why shaft and bearing condition matters more than it would on a light axle, and why worn gears make a poor base for a new locker.
Before choosing this unit, measure the housing, confirm the cover bolt pattern and check that the shafts have the correct spline count. Gear ratio changes often come with a new ring and pinion set, and the carrier should be shimmed and set up by a shop that knows these axles. Once installed, check the air line for kinks and check the fluid level after the first trail outings.
- Look for worn axle shafts and leaking seals before fitting
- Consider new bearings when the carrier is opened
- Confirm the cover bolt pattern before ordering a gasket
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | RD173 |
| UPC | 9332018015525 |
| Differential type | Selectable air locker |
| Axle manufacturer | Dana |
| Axle type | Dana 70 or Dana 80 |
| Axle spline count | 35 splines |
| Gear ratio | 4.10 down |
| Axle location | Rear |
Vehicle fitment
The RD173 is matched to the axle housing, which should be a Dana 70 or Dana 80. The 35 spline shafts and 4.10 down gearing complete the match. Match your vehicle’s year, model and trim before you order.
Front axle use and other spline counts fall outside the stated specifications. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The air supply is the setup item to finish first, because the compressor must be in place before the locker can engage. Gear and carrier setup for a 70 or 80 housing belongs with an axle shop that has done these before.
What’s included
Included: the RD173 air locking differential.
Not included: An ARB onboard air compressor, required to activate the locker.









