Overview
The AirLift Y-Tee, part number 21842, is a Y fitting that splits one 1/4 inch tube line into two separate lines. It uses push lock fittings for the 1/4 inch tube and has a 1/16 inch mounting hole. It is universal fit.
Key features
- Splits one 1/4 inch line into two separate lines
- Push lock fittings make tube connections
- 1/16 inch mounting hole
- Y fitting type
Routing a split air line
A tee lets one supply feed two branches, which is useful when a compressor line needs to run to two accessories. Place the tee where both branches can leave with gentle curves rather than sharp bends. Tubing that is pushed in at an angle tends to pull loose, so keep the lines straight at each connection.
Push lock fittings grip the tube, but the tube end must be clean and cut square for a reliable seal. Mark the insertion depth, and check that each line stays put after a gentle tug. Plan clips or brackets so the weight of the lines does not load the tee.
- Cut tube ends square and free of burrs
- Keep branch lines short where possible
- Check each connection for leaks after pressurizing
Specifications
| Brand | AirLift |
|---|---|
| Part number | 21842 |
| Fitting type | Y fitting |
| Tube size | 1/4 inch |
| Connections | Push lock fittings |
| Mounting hole | 1/16 inch |
| Fitment | Universal fit |
Vehicle fitment
Universal fit, so the Y-tee is not tied to a vehicle. Match the 1/4 inch tube size to the lines it will split.
Installation notes
Cut the tube square before pushing it into a push lock fitting, and depressurize the air system first. The 1/16 inch mounting hole is there for securing the tee.
What’s included
One Y-tee is included.
Not included: The 1/4 inch tubing that runs to and from the tee.









