Overview
The Rugged Ridge 11235.34 is a set of D-ring isolators for 3/4 inch recovery shackles. Each polyurethane isolator slips over the outside of the shackle, keeping the metal off the bumper and mounting points when the rig bounces on the trail. It is a universal fit, so it is not built around a vehicle year, model or trim, and shackle size determines the match.
The urethane washers in the set handle the other contact point by sitting between the shackle pin and the mounting tab. Rugged Ridge makes the same isolator for 7/8 inch shackles, and the color range runs from Black and Red to Green, Yellow and Pink.
Key features
- Polyurethane body that absorbs impact between the shackle and recovery points
- Covers all portions of the shackle, not only the outer edge
- Urethane washers isolate the shackle pin from the mounting tab
- Helps quiet the clang of shackles against a bumper
- Sized for 3/4 inch shackles
- Set of 2 isolators and 4 washers
Trail use and inspection
Recovery gear sees more stress than most accessories on a rig, so it is worth checking the shackle and its sleeve after every run. On a rocky trail the shackle can swing hard against the bumper, and a sleeve that has shifted leaves the metal exposed again. A quick look before each climb confirms the sleeve is still covering the contact points.
Shackle sleeves are simple parts, but they depend on the shackle staying in good condition. Keep pins clean, check that the bow is not bent, and replace any hardware that shows cracks. When you plan a longer trip, pack a spare set of washers so a worn pair can be swapped out without delay.
- Check the sleeve position before each climb
- Inspect the bow and pin for bends or cracks
- Pack spare washers for longer trips
- Clean the hardware after mud or water crossings
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 11235.34 |
| UPC | 804314290825 |
| Material | Energy-absorbing polyurethane with urethane washers |
| Shackle size | 3/4 inch |
| Set contents | 2 isolators and 4 urethane washers |
| Colors in line | Black, Red, Green, Yellow, Pink |
| Fitment | Universal fit |
Vehicle fitment
Universal fit, with no vehicle year, model or trim named. Selection depends on the shackle: this isolator is for 3/4 inch shackles.
Measure your shackle pin and body before ordering, because the 7/8 inch version of this line is a different size.
Installation notes
Work the polyurethane isolator over the shackle body until it snaps into place, then position a washer on each side of the mounting tab at the pin. Confirm the isolator fully covers the shackle where it meets the bumper before recovery use.
What’s included
A set with 2 isolators and 4 urethane washers, packed together.
Not included: the shackle.




















