Overview
The Fab Fours Transfer Case Skid Plate, part number JK3031-1, protects the transfer case on the Jeep Wrangler JK. It features a 2-stage matte black powder coat over 12-gauge steel and fits 2007 to 2018 Wrangler and Wrangler Unlimited models.
The plate is designed to work with the Fab Fours Oil Pan Skid and Gas Tank Skid, and the company’s Armor System is built around that set. It uses stainless steel mounting hardware and is 100 percent made in the USA. The installation requires cutting or drilling.
Key features
- Covers the transfer case on two-door and four-door Wrangler JK models
- Designed for use with the Oil Pan Skid and Gas Tank Skid
- 2-stage matte black powder coat finish
- Stainless steel mounting hardware
- 12-gauge steel construction
- Made in the USA
Transfer case guard duty
The transfer case sits between the transmission and the driveshafts, and it is often one of the lowest components on a Wrangler. A guard under it takes the first hit from ledges and rocks, which helps keep the case housing and its drain and fill plugs undamaged. Check that the guard does not restrict the drive shafts or limit their articulation.
Transfer case fluid should be checked on schedule, and a guard that makes the plugs harder to reach can turn a routine service into a larger job. Note where the fill and drain points sit relative to the plate before fitting, and tighten the hardware evenly.
If you run the oil pan and gas tank plates alongside this one, their edges meet along the vehicle’s underside. Check that the seams between them leave no gap that could catch a rock, and that no plate pulls against another during suspension travel. Recheck the hardware after the first few trail runs.
- Keep fill and drain plugs reachable before fitting
- Check drive shaft clearance through full articulation
- Inspect the guard after each rocky trail day
- Align seams between adjacent plates
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | JK3031-1 |
| UPC | 5810114169 |
| Position | Transfer case |
| Material | 12-gauge steel, 3/16 inch thick |
| Finish | 2-stage matte black powder coat |
| Mounting hardware | Stainless steel |
| Weight | 40 lb |
| Height | 21 inches |
| Width | 16 inches |
| Length | 48 inches |
| Installation | Cutting or drilling required |
Vehicle fitment
It fits the 2007-2018 Jeep Wrangler (JK), including Unlimited models. The JL and earlier TJ and LJ generations are not covered, so confirm your vehicle’s year, model and trim before ordering.
Other Wrangler generations, including the JL, are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires cutting or drilling. The plate is designed to be fitted with the oil pan and gas tank skids, so plan the set together before starting.
What’s included
One transfer case skid plate with stainless steel mounting hardware.





