Overview
The Rancho RS6210 is a pair of front control arm skids for the 2007 to 2016 Jeep Wrangler JK and the 1997 to 2006 Jeep Wrangler TJ. The skids mount to the front lower control arms at the axle end, where they help protect the arms and the factory brackets from rocks and ledges.
The skids are made from 3/16-inch thick steel with a red powder coat finish. The bolt-on installation takes only minutes and needs no cutting or drilling. The skids are designed to reduce hang-ups and damage to the factory brackets.
Key features
- Mounts to the front lower control arms at the axle end
- 3/16-inch thick steel construction
- Red powder coat finish
- Bolt-on installation, no cutting or drilling required
- Designed to reduce hang-ups and damage to factory brackets
- Suitable for two-door and four-door models
Protecting the Front Axle on Trail
Front lower control arms reach down toward the axle, where rocks and ledges can strike the arm and the factory brackets. A skid on the arm spreads impact over a larger surface, so a hit from a rock is less likely to bend or crack the mount. The skid is a shield for the arm, not a replacement for it.
Check the skid and its bolts after each trip over rough ground. Look for dents, cracked welds or loose hardware, and make sure the skid still clears the axle through full suspension travel. Mud, rock debris and wet grit can build up around the arm, so rinse the area after off-road use to reduce corrosion on the bolts.
- Check bolts after rough trails
- Look for dents or cracked welds
- Confirm axle clearance at full droop
Specifications
| Brand | Rancho |
|---|---|
| Part number | RS6210 |
| UPC | 39703062107 |
| Type | Control arm skid |
| Position | Suspension control arm, front lower, axle end |
| Material | Steel, 3/16 inch thick |
| Finish | Red powder coat |
| Installation | Bolt-on, no cutting or drilling |
Vehicle fitment
They fit the 2007 to 2016 Jeep Wrangler JK, including the 70th and 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X models in two-door and four-door bodies, and the 1997 to 2006 Jeep Wrangler TJ, including the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X models.
They do not fit the JL or the LJ. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The skids mount with bolts and require no cutting or drilling. Because they mount to the lower control arms at the axle end, check clearance between the skid and the axle before driving on uneven ground.
What’s included
The control arm skids under part number RS6210, with the mounting hardware needed for the bolt-on installation.









