Overview
The Trail Gear 110050-1 is a U-bolt nut that threads onto a U-bolt to clamp it against an axle or spring. It is sized at 9/16 in. Measure the thread and compare it with your U-bolt before fitting.
Many U-bolt setups count nuts separately from the U-bolt itself, so confirm whether your installation needs single nuts or a full set.
Choosing and fitting U-bolt nuts
U-bolt nuts carry most of the clamping force, so the threads and the seating face matter as much as the nominal size. A nut that is worn or cross-threaded will not hold torque, and the U-bolt can slip on the axle under load. Before fitting, run each nut down the U-bolt thread by hand to confirm it turns freely and seats square against the plate.
Nuts are usually replaced in matching sets with the U-bolt they go on. Mixing old and new fasteners can leave the clamp load uneven, and one tight nut can pull the others out of line. Tighten in a cross pattern, then recheck after the first few drives, because the spring seats and the clamp settles as the vehicle works. Clean threads and dry seating faces give the most consistent result.
- Run each nut down by hand before torquing
- Replace nuts that show thread damage
- Match nut diameter and pitch to the U-bolt
- Use a torque wrench and recheck after initial drives
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 110050-1 |
| UPC | 70000655838 |
| Type | U-bolt nut |
| Size | 9/16 in. |
Vehicle fitment
Confirm fit for your vehicle’s year, model and axle before ordering. Compare the thread and the 9/16 in. size with your own U-bolt before using it.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The package is one U-bolt nut. Check the package contents against your installation before starting, including any washers you need.







