Overview
The Skyjacker SKY916X318X912 is a replacement U-bolt sold as a single bolt. Skyjacker E-coats the bolt for corrosion resistance, and two nylon insert lock nuts come with it.
Skyjacker’s U-bolts run in many sizes and end shapes, from square to round to semi-round, with lengths from 1.75 to 19 inches. Check the old bolt’s thread and bend against SKY916X318X912 before ordering.
Key features
- E-coat for corrosion resistance
- Sold as a single U-bolt
- Two nylon insert lock nuts supplied
- Replacement for a spring or axle clamp
Reusing the clamp hardware
Reusing the spring plate and clamp hardware is common when swapping a U-bolt, but each part should be judged on its own condition. A plate that is flat and free of cracks can stay, while one with worn bores or rounded seating surfaces should be replaced so the new bolt clamps evenly.
Nuts that have been used several times lose some grip, so new nylon insert lock nuts are a reasonable choice when the bolt goes in. Clean the threads, confirm the bolt seats square on the plate, and tighten both legs in small, even steps to the torque value for your vehicle.
- Inspect the plate for cracks
- Replace plates with worn bores
- Use fresh lock nuts when the bolt is new
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | SKY916X318X912 |
| Product type | U-bolt |
| Finish | E-coated |
| Included hardware | 2 nylon insert lock nuts |
| Sold as | Single |
Vehicle fitment
The universal fit label means the bolt must be matched to the spring and axle. Measure the clamp and compare your truck’s year, model and trim before buying.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Fit the SKY916X318X912 over the spring and axle, add the lock nuts supplied with it and tighten evenly to the torque figure for your vehicle. Make sure the bolt sits flat before the final turn.
What’s included
One SKY916X318X912 U-bolt and two nylon insert lock nuts.








