Overview
The Trail Gear 130089-1-KIT is a set of replacement boots for tie rod ends. Trail Gear says they are made to fit its FJ 80 TRE and many other popular tie rod ends.
The boots use a UV resistant NBR (Naturally Blended Rubber) compound and serve as a direct replacement for Trail Gear hi-steer TRE units. Installation needs only grease and snap ring pliers.
Key features
- UV resistant NBR (Naturally Blended Rubber) compound
- Direct replacement for Trail Gear hi-steer TRE units
- Made to fit FJ 80 TRE and other popular tie rod ends
- Installation needs grease and snap ring pliers
Before you install
A tie rod end boot works as a seal. It keeps grit and water away from the ball joint and holds grease inside, so a split boot lets the joint wear faster than it should. Boots usually fail from age, UV exposure, or a stone cut, and the signs are dried or cracked rubber, grease smeared on the outside, or play in the steering when the joint is loaded.
Before ordering, identify the tie rod end model rather than relying on the vehicle. Remove the old boot carefully and compare its diameter, ridge profile and length with the new one. Repack the joint with fresh grease before seating the snap ring, and check the boot for twists after the first few drives.
- Inspect the boot at every oil change
- Replace a boot that shows cracks or grease loss
- Clean the seating area before refilling grease
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 130089-1-KIT |
| UPC | 70000621457 |
| Material | NBR (Naturally Blended Rubber) |
| UV resistance | UV resistant |
| Fitment | Universal Fit |
Vehicle fitment
Trail Gear says these fit its FJ 80 TRE and many other popular tie rod ends, labeled Universal Fit; no vehicle is named.
Confirm your vehicle’s year, model and trim before ordering. Match the boot to the tie rod end model rather than to a vehicle.
Installation notes
Trail Gear says installation requires only grease and a pair of snap ring pliers.
What’s included
Check the number of boots in the package against your installation before starting.
Not included: grease and snap ring pliers, both needed for installation.








