Overview
The Trail Gear Spline Input Gear, part number 100011-1, is a 23 spline input gear for a 2.28 gear set in the front case of a dual transfer case. It is made for gear-driven 4-cylinder transfer case assemblies.
This gear suits a dual transfer case build on a turbo or V6 when a 2.28 gear set is kept in the front case. The 23 spline 2.28 input gear is the part called for in that setup.
Key features
- 23 spline input gear
- Matches a 2.28 gear set in the front case of a dual transfer case
- Made for gear-driven 4-cylinder transfer case assemblies
- Trail Gear part number 100011-1 with UPC 70000621480
Gear wear and setup
Input gears in a dual transfer case carry engine torque into the gear set, so they work under constant load. Correct mesh between the input gear and the matching gears is essential. Mesh that is too tight causes heat and early wear, while mesh that is too loose can cause noise and chatter under load.
A new gear is usually fitted with fresh bearings, shims and seals, and those parts should be checked against the old ones before assembly. Break in new gears gradually, and watch for changes in noise or temperature during the first drives. Keep the fluid clean and at the right level, and inspect it for metal particles at each service interval.
- Check mesh and backlash before sealing the case
- Look for metal particles in the case fluid
- Replace seals removed during the job
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 100011-1 |
| UPC | 70000621480 |
| Part type | Spline input gear |
| Spline count | 23 |
| Gear set | 2.28 |
| Transfer case type | Gear-driven 4-cylinder assemblies |
Vehicle fitment
Fit depends on your transfer case: it must be a gear-driven 4-cylinder assembly with a 2.28 gear set in the front case. Confirm your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Gears in a dual transfer case need professional setup and correct backlash, and a break-in period is normal for new gear sets. Work only with the vehicle raised and supported on stands.
What’s included
Only the input gear is named. No bearings, shims or hardware are described.
Not included: The 2.28 gear set, the front case and the rest of the dual transfer case are not included.









