Overview
The Trail Gear 186025-KIT is a rod end kit with a 7/8 inch-14 shank, a 5/8 inch bore and a right hand thread. Rod ends, also called heim joints, sit at the ends of steering and suspension links and let the joint pivot as the axle moves. This kit has a 4340 chromoly body with a zinc finish and an AISI 52100 ball that is hard chrome-plated. Trail Gear marks it universal fit and includes the jam nut.
Key features
- Main body of 100% 4340 chromoly with a zinc coating
- AISI 52100 ball with a hard chrome-plated finish
- Teflon liner
- Jam nut included
- Right hand thread direction
Installing and checking the joint
A rod end works as a pivot between a link and a bracket, so most of its life depends on how well it is lubricated and protected from grit. The Teflon liner reduces friction against the ball, which keeps movement smooth without constant greasing. The chrome plated ball resists surface wear, but the zinc body is the part to check for chips and corrosion after rough trips.
When fitting the joint, thread the shank in fully and run the jam nut tight against the body so the setting does not drift. Keep the link angle within the joint’s travel, since a rod end set at its limit can bind under load. Inspect the threads and jam nut after the first few outings, and replace the joint if the ball feels rough or the liner has worn through.
- Check the zinc finish for chips after trail use
- Tighten the jam nut against the body after setup
- Replace the joint if the ball binds or feels rough
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 186025-KIT |
| UPC | 70000621723 |
| Body material | 100% 4340 Chromoly |
| Body finish | Zinc coating |
| Ball material | AISI 52100, hard chrome-plated |
| Liner | Teflon |
| Shank | 7/8 inch – 14 |
| Bore | 5/8 inch |
| Thread direction | Right hand |
Vehicle fitment
This rod end is not vehicle-specific. Trail Gear marks it universal fit and names no year, make or model. Match the shank, bore and thread direction to the joint you are replacing.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Set the joint to the link length you need, then tighten the jam nut against the body. Check that the 7/8 inch-14 shank threads fully into the link before loading the joint.
What’s included
The kit comes with the rod end and the jam nut.









