Overview
The Trail Gear 120008-1-KIT is a bare steel rock slider mount kit with gusset plates that tie the rock slider to the frame. It fits 1984–1995 Toyota 4Runner and 1979–1995 Toyota Pickup models.
The plates weld to the frame and the rock slider welds to the plate, so installation is by welding rather than bolting. The kit is made from 3/16 in plate steel. It comes in 58 in, 67 in and 78 in lengths. The 58 in and 67 in kits have 6 plates and 6 gussets each, and the 78 in kit has 8 plates and 8 gussets. Confirm which length you have before ordering.
Key features
- Gusset kit with plates for the frame and triangle corner gussets
- Bare steel finish
- Made from 3/16 in plate steel
- Tubular guard with tubular standoff design
- Welding required for installation
Frame prep for mount plates
Gusset mounts carry a lot of load from the rock slider into the frame, so the frame has to be sound before welding. Remove paint, rust and undercoating from the plate contact points. A clean, flat contact surface lets the plate and gusset fuse properly and reduces the chance of a weak joint.
Plate steel tends to pull and distort during welding, so tack the parts into position and check alignment with a square before finishing the welds. Confirm that the gusset count matches the plate count for your kit length before fitting anything.
- Strip paint and rust from every contact point
- Tack and check alignment before full welds
- Keep weld heat away from fuel and brake lines
- Inspect welds for cracks after the first off-road trip
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 120008-1-KIT |
| UPC | 70000621330 |
| Material | 3/16 in plate steel |
| Finish | Bare steel |
| Type | Tubular guard with tubular standoff |
| Installation | Welding required |
| Kit lengths | 58″, 67″ and 78″ |
| Piece count | 58″ and 67″: 6 plates and 6 gussets; 78″: 8 plates and 8 gussets |
Vehicle fitment
It fits the 1984–1995 Toyota 4Runner (DLX, SR5) and 1979–1995 Toyota Pickup (Base, Base Turbo, DLX, DLX Turbo, SR5, SR5 Turbo).
Other Toyota models and model years outside these ranges are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required. The plates weld to the frame and the rock slider welds to the plate, so frame welding experience is needed. A poor frame weld is hard to correct, so have a qualified welder handle the job.
What’s included
Gusset plates and gussets for the mount.
Not included: The rock slider, which welds to the mount plate.









