Overview
Trail Gear’s Longfield driveline spacer kit, part number 301697-1-KIT, addresses a driveshaft that runs short after a suspension lift. The kit is described with 1 inch and 1.5 inch spacers and bolts.
Universal fit applies, so no particular year, make, model or trim is tied to this kit.
Key features
- Spacer for a driveshaft that runs short after a lift
- 1 inch and 1.5 inch spacer options
- Bolts provided with the spacers
- Universal fit, not tied to a particular year, make, model or trim.
Choosing spacer thickness
Spacer thickness sets how much the driveline is extended, so the first step is working out how far the driveshaft has been pushed out of place by the lift. Compare the current driveshaft length and the slip yoke engagement, then decide whether a 1 inch or 1.5 inch spacer brings the driveline closer to its intended geometry. Avoid choosing by feel alone.
Most people end up checking the joints after a spacer goes in. Look at the U-joints for wear, play and binding, and consider replacing worn joints while the driveline is apart, since they will carry the new angles. Clean the mating faces before assembly, and recheck the bolts after the first few trail runs while watching for new noises.
- Measure the current driveshaft length
- Check slip yoke engagement
- Inspect U-joints during installation
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 301697-1-KIT |
| UPC | 700006929981 |
| Spacer sizes | 1 in and 1.5 in |
| Hardware | Bolts included |
| Fitment listing | Universal Fit |
Vehicle fitment
No vehicle is named for this kit, so it is not tied to a year, model or trim. Compare your current driveshaft length and joint angles with the spacer size you plan to use.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Changing driveshaft length also changes the joint angles, so have the driveline checked for angle and vibration once the spacers are fitted.
What’s included
Spacers in 1 inch and 1.5 inch sizes with bolts, per the brand’s description.
Not stated: Confirm the number of spacers in your kit before installing.









