Overview
The Trail Gear 105079-3-KIT is a driveline spacer kit with one 1 in. long spacer made from 6061 T6 aluminum, supplied with mounting hardware. It can be used on a front or rear drive shaft.
A driveline spacer is a short aluminum part fitted into the driveline, so measure your application before installing. Check your vehicle’s year, model and trim against your driveline size before buying.
Key features
- Made from 6061 T6 aluminum
- One spacer, 1 in. long, per kit
- Mounting hardware included
- Use on a front or rear drive shaft
Measuring before you install
Before fitting a spacer, measure the distance it needs to cover and confirm there is enough clearance around the shaft for the new position. A short spacer changes the joint angles less than a long one, so the measurement should be taken with the vehicle at its normal ride height. Mark the shaft position before removing anything so the alignment can be restored correctly.
Inspect the yokes and slip joint for wear before assembling the driveline, because a worn part can bind once the spacer changes its position. Check that the mounting hardware is clean and undamaged, and replace any fastener that shows stretching or corrosion. Note where the shaft sits after assembly and recheck it after the first few drives on rough ground.
- Measure clearance at full shaft travel
- Inspect yokes and slip joints for wear
- Replace damaged mounting fasteners
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 105079-3-KIT |
| UPC | 70000621220 |
| Material | 6061 T6 aluminum |
| Length | 1 in. |
| Kit contents | One spacer and mounting hardware |
| Application | Front or rear drive shaft |
Vehicle fitment
It fits a front or rear drive shaft. Confirm fit by year and model before ordering.
Measure your driveline length first, then match your vehicle’s year, model and trim before buying.
What’s included
Each kit contains one spacer and mounting hardware.









