Overview
The Trail Gear 170004-KIT is a knuckle pull scale used to set the shims on a steering knuckle. It is a shop tool rather than a vehicle part, and it fits universal applications.
Adding shims above and below the knuckle makes it tighter, and the pull scale shows whether the setting is right. Check the shims with a pull scale whenever new knuckle bearings are installed.
Key features
- Measures the force needed to move the knuckle
- Used for setting shims above and below the knuckle
- Used when new knuckle bearings are installed
- Universal fit
Steering knuckle service basics
A steering knuckle pivots on bearings or ball joints that carry the weight of the front wheel and the forces from steering. Shims control how tightly those parts sit together, and a small change in shim thickness can make a large difference in how freely the knuckle turns. Setting them by feel alone is hard to repeat, which is why a force reading gives a more consistent result from one job to the next. The reading is most useful when taken with the steering arm free and the wheel supported in a stable position.
Good service practice also includes clean surfaces, correct torque on the knuckle fasteners and a check for play after the work is done. Worn bearings, dry seals and loose hardware can all change the result, so inspect them before setting shims. If the knuckle feels rough or binds through its travel, address the cause before taking a final reading. Keep notes of shim stack-up so the setting can be repeated when parts are replaced.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 170004-KIT |
| UPC | 70000621293 |
| Type | Knuckle pull scale kit |
| Fitment | Universal fit |
| Target force | Knuckle should not move until about 15 lb is applied to the steering arm |
Vehicle fitment
The scale is not made for a particular vehicle. It is used on the knuckle and steering arm of the vehicle being serviced, with the tie rod or drag link disconnected.
Installation notes
Remove the tie rod or drag link before attaching the scale to the steering arm. Take the reading before the felt is installed on the back side of the knuckle, and only then install it.
What’s included
Pull scale kit, part number 170004-KIT. Check the package contents against your installation before starting.









