Overview
The Trail Gear 110029-1-KIT is a rear sloped spring hanger kit for Toyota pickups and 4Runners. It includes frame jigs, and the springs bolt on using the included bushings and shackles.
It fits 1979-1995 Toyota Pickup models and 1984-1995 4Runner models in the trims shown below. Other models are not covered.
Key features
- Rear position kit with a sloped hanger design
- Frame jigs help place the shackle tubes in the frame
- Bushings and shackles are included.
- Suited to the listed 1979-1995 Toyota pickups and 1984-1995 4Runners
Choosing a spring hanger setup
A spring hanger carries the leaf spring’s mounting point and moves load into the frame, so its angle and location shape how the axle travels over bumps. A sloped design changes the angle the spring leaves the frame, which affects how the pack sits under load and how much room it has to flex. Before welding, set the spring eye and shackle against the hanger so the spring is not pinched or stretched at full droop.
Bushings, shackles and bolts wear at similar rates, so they are often replaced when the hanger is installed. Check bushings for cracking or flattening and shackle bolts for play. Grease the bolts and inspect the welds after the first few trail runs to catch loosening early. Frame alignment is worth a second look from a qualified fabricator before the vehicle sees hard use.
- Spring eye and shackle clearance at full droop
- Bushing condition before reuse
- Weld and bolt checks after early trail use
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 110029-1-KIT |
| UPC | 70000621469 |
| Position | Rear |
| Hanger shape | Sloped |
| Included | Frame jigs, bushings, shackles |
| Type | Spring hanger kit |
Vehicle fitment
It fits 1984-1995 Toyota 4Runner (DLX, SR5) and 1979-1995 Toyota Pickup (Base, Base Turbo, DLX, DLX Turbo, SR5, SR5 Turbo).
Toyota trucks and SUVs outside those listed models and years are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Place the frame jigs under the cab body mount and mark the frame. Cut the tube holes with a torch, slide the tubes in place and weld them. Clamp the hanger in position, weld it, then bolt the springs on with the included bushings and shackles. Cutting and welding a frame should be left to a qualified fabricator.
What’s included
Frame jigs, bushings and shackles.
Not included: leaf springs.









