Overview
The Trail Gear Interlocking Tube Clamp kit, part number 180096-KIT, is a 1.25 in clamp for supporting a tube across a truggy or buggy. It is machined from 100% 4130 chromoly.
The interlocking design lets you remove a motor, transmission or seat while the tube stays in place. It is a universal fit clamp, and no vehicle years, makes or models are named.
Key features
- 100% 4130 chromoly construction
- 1.25 in size
- Counter sunk Allen head screw
- Flexibility for removing a motor, transmission or seat
Tube clamp layout
A tube clamp holds a support tube across the frame, so the layout of your buggy or truggy decides where it can sit. Clamps usually go where the tube meets the frame rails, and the interlocking pattern lets the tube be separated when you need access to the motor, transmission or seat. Plan the tube run before drilling anything.
Steel and chromoly tubes can be cut and fitted to length, but a clamp is only as good as the tube it grips, so measure the outside diameter first. Fasteners should be snug but not overtightened, since a crushed tube wall weakens the support. Periodic inspection matters on a rough-terrain build because vibration can loosen screws over time.
- Check tube outside diameter before ordering
- Plan the support tube route before mounting
- Inspect the clamp for cracks after rough runs
- Keep Allen screws snug and rechecked
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 180096-KIT |
| UPC | 180096000006 |
| Material | 100% 4130 chromoly |
| Size | 1.25 in |
| Fastener | Counter sunk Allen head screw |
Vehicle fitment
This is a universal fit clamp. No year, make or model is named, so fit depends on the 1.25 in tube size and how your frame is laid out.
Measure your support tube before ordering, since tube size decides the fit.
Installation notes
Fastening uses a counter sunk Allen head screw, so plan on an Allen key when mounting the clamp.
What’s included
Confirm the number of clamps and bolts you receive against your build plan before starting.









