Overview
The Crown Automotive 5252508 is a pinion outer bearing set for the Dana 30, Dana 35 and 8.25 axles used in many Jeep Cherokee, Comanche, Grand Cherokee, Liberty and Wrangler models.
The set contains 1 bearing and 1 cup for the outer pinion position. Crown’s description ties the part to specific axles: Dana 30 front axles, Dana 35 rear axles and Chrysler 8-1/4 inch rear axles. That makes the axle under your Jeep as important as the year when you choose it.
Pinion bearings support the pinion gear that drives the ring gear in a Jeep axle. The outer bearing sits nearest the yoke. This set is a single bearing and cup, so it replaces one bearing rather than providing a full rebuild kit.
Key features
- Pinion outer bearing set
- Includes 1 bearing and 1 cup
- Dana 30, Dana 35 and 8.25 axles
- Front and rear axle applications
- Direct fit
- Wide Jeep coverage
Identifying your axle
Dana 30, Dana 35 and 8-1/4 inch axles use different pinion bearings, so the axle under the vehicle decides the part more than the model year does. Check the axle casing and any tag on the housing before ordering, and compare the old bearing and cup side by side if the set is being used for a repair.
The outer pinion bearing carries load from the yoke side of the gear set. When it is replaced, the ring and pinion should be inspected for pitting, chipping or scoring, because a bearing fitted to a worn gear set rarely lasts long. Gear setup and preload are best handled by someone experienced with axles.
- Read the axle housing markings before ordering
- Compare the old bearing and cup with the new set
- Inspect the ring and pinion teeth before reassembly
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 5252508 |
| UPC | 848399075083 |
| Part type | Pinion outer bearing set |
| Contents | 1 bearing and 1 cup |
| Position | Outer |
| Axles | Dana 30 front, Dana 35 rear, Chrysler 8-1/4 inch rear |
| Fit type | Direct fit |
Vehicle fitment
It fits the 1984–2001 Jeep Cherokee (XJ), 1986–1992 Comanche, 1999–2004 Grand Cherokee (WJ), 1993–1998 Grand Cherokee (ZJ), 2002 Liberty (KJ), 1997–2006 Wrangler (TJ) and 1987–1995 Wrangler (YJ). The axle applies to each vehicle: Dana 30 front on the 1997–2006 TJ, 2000–2001 XJ and 1993–2004 Grand Cherokee; Dana 35 rear on 1987–2006 Wranglers, 1984–2001 XJ, 1986–1992 Comanche, 1993–2004 Grand Cherokee and 2002 Liberty; Chrysler 8-1/4 inch rear on 1991–2001 XJ and 2002–2005 Liberty. Check fit against your vehicle’s year, model and trim before ordering.
Wrangler (JK) and generations not named are outside this set, and each vehicle applies only with the axle stated. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The Chrysler 8-1/4 inch and Dana axles use different bearings, so identify your axle before ordering.
What’s included
- 1 outer pinion bearing
- 1 bearing cup
Not included: Seals, shims, crush sleeve and other installation parts.














