Overview
The Trail Gear 110045-1-KIT is a front spring hanger for Toyota pickups and 4Runners, supplied with greasable 120mm bolts, bushings, nuts and gussets. It is designed to be welded into the frame at the front spring location.
It fits 1984-1995 Toyota 4Runner DLX and SR5 models and 1979-1995 Toyota Pickup models in the trims shown below.
Key features
- Front position hanger
- Greasable 120mm bolts included
- Bushings, nuts and gussets included
- Fits 1979-1995 Toyota pickups and 1984-1995 4Runners
Front hanger geometry
At the front, the hanger guides the spring eye and the shackle as the axle cycles, so its position relative to the cab body mount matters. Small changes in angle shift how the spring loads its bushings, which is why alignment is checked before the welds are final. Look at the spring’s movement through its full range of travel once everything is bolted up.
Front hanger bushings and shackle bolts see constant motion, so they need regular attention. Greasing the bolts keeps the bushings moving freely and reduces squeaks. Inspect the hanger body near the welds for cracks, and check that the spring eye sits square to the hanger after any suspension change. Replace worn parts before they damage the frame.
- Spring eye alignment through full travel
- Greasing bolts at regular intervals
- Crack checks around hanger welds
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 110045-1-KIT |
| UPC | 70000621541 |
| Position | Front |
| Bolts | Greasable 120mm |
| Included hardware | Bushings, nuts, gussets |
| Type | Spring hanger |
Vehicle fitment
It fits 1984-1995 Toyota 4Runner (DLX, SR5) and 1979-1995 Toyota Pickup (Base, Base Turbo, DLX, DLX Turbo, SR5, SR5 Turbo).
Other Toyota models, including ones outside these lines, are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Place the frame jigs under the cab body mount, mark the frame and cut tube holes with a torch. Slide the tubes into place and weld them, then clamp the front hanger and weld it. Frame cutting and welding should be left to a qualified fabricator.
What’s included
Greasable 120mm bolts, bushings, nuts and gussets.
Not included: Leaf springs and frame tubes.









