Overview
Part 111279-KIT is Trail Gear’s 16 in Rock Assault axle limit strap, made with six layers of nylon webbing. It limits how far a shock can extend, helping prevent overextension that can break the shock on uneven ground.
The strap is universal fit, so it is chosen by shock length and sold individually. Its six-layer nylon design is intended to restrain shock travel.
The 16 in size suits longer shocks. Compare the specification table with your shock measurements, including length, buckle material, mounting holes and tolerance.
Key features
- Six-layer nylon webbing with little stretch under load.
- Buckles made from 4130 heat-treated Chromoly Steel and zinc-plated.
- Clips that reduce abrasion are built into each buckle.
- Nylon rated at 9,000 lb test.
- Half-inch mounting holes, with length measured to their center.
Matching the strap to your shock
An axle limit strap works by stopping a shock short of full extension, so the shock is not forced past its travel on rough trail. The strap should be measured against the shock’s extended length rather than the vehicle, because length is what controls when it takes the load. Clips and buckles matter too, since they keep the strap in place and reduce wear where it rubs against the shock body or axle.
Inspect the strap regularly for fraying along the webbing, cracked or bent buckles, and worn clips. Replace the strap when the nylon shows cuts or cords pulling out, since a damaged strap may not limit extension as intended. When a shock is replaced or the suspension height changes, measure again before refitting the strap.
- Measure the shock’s extended length before ordering
- Inspect webbing for fraying or cuts
- Check buckles for cracks and clips for wear
- Re-measure after changing shocks or suspension height
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 111279-KIT |
| UPC | 70000640909 |
| Length | 16 in |
| Layers | Six |
| Webbing | Nylon |
| Test rating | 9,000 lb test |
| Buckle material | 4130 heat-treated Chromoly Steel |
| Buckle finish | Zinc-plated |
| Mounting holes | 1/2 inch |
| Length tolerance | +/- 1/4 inch |
Vehicle fitment
Trail Gear marks this strap as universal fit, so no year, make, model or trim applies. Match the 16 in length to the shock before choosing.
Installation notes
Sized about an inch under the shock, the strap stops the shock short of full extension. Measure the shock before you commit to the 16 in length.
What’s included
The 16 in strap is sold individually.
Not included: The shock and its mounting bolts are not part of this kit.






