Overview
The TeraFlex FlexArm joint rebuild kit, part number 1951450, contains the replacement components needed to rebuild a TeraFlex FlexArm joint. It is meant for periodic rebuilds, since grit, grime, dust and fluids wear the joint tolerances over time.
The kit includes a chrome plated misalignment ball, two urethane bushings, a large retainer washer and a snap ring. No vehicle years or models are given, so confirm which FlexArm joints it suits before ordering.
Key features
- All required replacement components to rebuild a FlexArm joint
- Chrome plated misalignment ball
- Two urethane bushings
- Large retainer washer and snap ring
- Intended for periodic rebuilds to restore top working condition
Before you rebuild
A FlexArm joint carries constant load as the axle articulates, so its bushings and ball take the stress of every off-road flex. Over time, dirt and water work into the joint and widen the clearances, which shows up as clunking, looseness or uneven articulation. Rebuilding the joint restores the original fit before wear reaches the control arm mount.
Before starting, clean the joint thoroughly and inspect the housing for cracks or an oval bore. Replace the bushings and ball together, since a new ball running in worn bushings wears out quickly. Seat the snap ring and retainer washer correctly, and grease the joint as your setup’s rebuild procedure directs.
- Check the joint for play before disassembly
- Inspect the control arm for bends or cracks
- Re-check the retainer hardware after the first few trail runs
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1951450 |
| UPC | 843885024767 |
| Misalignment ball | Chrome plated |
| Bushings | Two urethane |
| Retainer | Large retainer washer |
| Retention | Snap ring included |
Vehicle fitment
Only a Universal Fit tag appears for this rebuild kit, so match the joint to your FlexArm before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
A chrome plated misalignment ball, two urethane bushings, a large retainer washer and a snap ring.
Not included: The FlexArm control arm itself is not part of this kit.









