Overview
The TeraFlex Alpine Adjustable Rear Lower Control Long Arm Kit, part 1315540, is a rear lower control arm kit for JK and JKU Wrangler models with 3-6 inch lifts, covering the 2007-2018 Jeep Wrangler (JK).
The Alpine long control arms and long arm brackets provide full alignment adjustability. On higher lifts the arms reposition the frame-end mounting points closer to factory orientation, which reduces bushing stress during droop and shock load.
The kit can be added to an existing suspension lift, so owners who already run a lift can fit the arms without replacing the whole system.
Key features
- Full alignment adjustability for rear lower control arms
- Frame-end mounting points repositioned to near factory orientation on higher lifts
- Maintenance-free, factory-style bushings
- Can be added to an existing suspension lift
- Designed for 3-6 inch lifts on JK and JKU models
Alignment after long arm installation
Long control arms change the rear axle’s location and the angle of the lower links, so the alignment and driveline angles need to be checked after installation. Adjustable arms are designed to let you set these angles, but the setting only helps if it is measured. Confirm the pinion angle and driveshaft clearance across the full range of suspension travel.
Bushings in a long arm setup see higher loads during droop and shock compression, so inspect them regularly. Maintenance-free bushings still need a visual check for splitting, cracking or oil contamination. If the vehicle is run at a different lift height than the arms were set for, recheck the alignment before a long trip.
- Measure pinion angle after the install
- Check driveshaft clearance at full droop
- Inspect bushings for splitting after rough trips
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1315540 |
| Position | Rear lower |
| Type | Tube control long arm |
| Lift range | 3-6 inch |
| Bushings | Maintenance-free, factory style |
Vehicle fitment
The kit fits the 2007-2018 Jeep Wrangler (JK) in 2-door and Unlimited 4-door models.
It is not for the Wrangler TJ, LJ or JL, which are outside the JK range. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit must be used with the Alpine Long Arm Bracket Kit, part 1957000, which is not included. The arms are intended for vehicles with 3-6 inch lifts.
What’s included
The package is the rear lower control long arm kit only.
Not included: the Alpine Long Arm Bracket Kit, part 1957000, which TeraFlex says is required.









