Overview
The Ten Factory MG21103 is a pair of black outer axle tube seals for Dana 30 and Dana 44 front axles. They fit the 1984 to 2001 Jeep Cherokee XJ and keep mud and debris out of the front axle tubes.
Ten Factory describes these as a new, updated design. The seal is made of machined billet aluminum with a double lip seal, and it accommodates both factory and aftermarket axle shafts. Each seal has an easy access zerk fitting for grease.
The seals are sold as a pair and will not work with the passenger side vacuum disconnect two-piece axle shaft used on some Wranglers.
Key features
- Machined billet aluminum seal housing.
- Double lip seal to keep mud and water out of the axle tube.
- Accommodates factory and aftermarket axle shafts.
- Easy access zerk fitting for grease.
Grease and seal care
Axle tube seals work against a steady flow of mud, water and grit, so their condition shows up over time. Look for hardened lips, torn edges or grease leaking from the housing. Because the seal is machined billet aluminum, damage usually comes from debris cut into the lip rather than from the housing itself, so clean the area before each service.
Regular greasing helps the double lip seal stay pliable. Pump grease slowly through the zerk until fresh grease appears at the seal, then wipe away excess so it does not collect dirt. After deep water crossings, grease the seals again. Keep a spare seal on hand if you run the truck hard, since a failed seal lets contamination into the axle.
- Look for hardened or torn lips
- Grease slowly until fresh grease shows
- Grease again after deep water crossings
Specifications
| Brand | Ten Factory |
|---|---|
| Part number | MG21103 |
| UPC | 698231878965 |
| Axle | Dana 30 and Dana 44 front |
| Material | Machined billet aluminum |
| Color | Black |
| Quantity | Sold as a pair |
Vehicle fitment
These seals fit the 1984 to 2001 Jeep Cherokee XJ, with Dana 30 and Dana 44 front axles.
Wrangler models with a passenger side vacuum disconnect two-piece axle shaft are excluded. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check whether your front axle shaft is a two-piece vacuum disconnect design before you fit the seal, because the seal will not work with that shaft. The zerk fitting lets you grease the seal after installation.
What’s included
Two outer axle tube seals, sold as a pair.
















