Select your vehicle

SPOD Adapter Harness for ARB Compressor – 300-ARB

SPOD

Shop SPOD Switch Pods on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Slickrock 4X4 is a participant in the Amazon Associates Program. As an Amazon Associate we earn from qualifying purchases.

  • Adapter harness for an ARB compressor, part number 300-ARB
  • Works with sPOD switches and Source
  • Controls the compressor and front and rear lockers
  • 7-inch length helps eliminate multiple wires

Description

Overview

The SPOD Adapter Harness for ARB Compressor, part number 300-ARB, connects an ARB compressor to the sPOD switch and Source system so the compressor and front and rear lockers can be controlled. It is a universal application rather than a vehicle-specific part.

Key features

  • Built for use with an ARB compressor
  • Uses sPOD switches and Source
  • Controls the compressor and front and rear lockers
  • 7-inch length helps eliminate multiple wires

Routing and wire care

A compressor adapter harness sits between the compressor controls and the switches a driver uses on the trail. Plan the route before you start pulling wire. Label each wire at both ends so future troubleshooting is quicker. Keep the harness away from exhaust parts, moving suspension links and sharp body edges, and secure it with clips so it does not rub. Leave enough slack at connectors for flex when the axle articulates.

When the adapter is one part of a larger electrical setup, check each connection after installation. Look for loose pins, chafed insulation and corrosion at the terminals, especially in wet or muddy conditions. Re-check the clips after the first few trail runs, since vibration can loosen them. If a locker or compressor function behaves inconsistently, inspect the adapter connections before replacing any switch.

Specifications

Brand SPOD
Part number 300-ARB
UPC 700006892241
Length 7 inches
Compressor ARB compressor
Control system sPOD switches and Source
Lockers controlled Front and rear

Vehicle fitment

The adapter is a universal application, so it is not tied to a make, model or year. Fit depends on the ARB compressor and the sPOD components you wire it into.

Confirm your vehicle’s year, model and trim before ordering.

Installation notes

The adapter is meant to tie the ARB compressor into the sPOD switches and Source, so decide where the switches go before routing the 7-inch harness. Keep the battery disconnected until every connection is made.

What’s included

The adapter harness is the item described here. The ARB compressor, sPOD switches and Source are not included.

SKU: POD300-ARB Category:

Specification

Shipping weight 1.00 lbs
Package dimensions 7.00 × 1.00 × 1.00 in
brands

Questions & Answers

Is the SPOD 300-ARB harness made for ARB compressors?

Yes. It is an adapter harness for use with an ARB compressor. It controls the compressor and the front and rear lockers and works with sPOD switches and Source.

Does the 300-ARB adapter fit a specific vehicle?

No vehicle is named. The adapter is a universal application, so fit depends on the ARB compressor and the sPOD system you are wiring rather than on a model year.

How long is the 300-ARB adapter?

It is 7 inches long, which helps eliminate multiple wires. Check the harness routing against your planned switch locations before cutting any wire.

How should the adapter harness be inspected over time?

Inspect the harness every few months and after rough off-road trips. Look for cracked insulation, pulled pins and any wire that has rubbed through its sleeving. Clean corrosion from connectors with contact cleaner and reseat them fully before testing the compressor and lockers.

Find it on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Shop SPOD Switch Pods on Amazon