Overview
The Skyjacker SKY916X318X1312 is a single U-bolt with an E-coated finish for corrosion resistance. Two nylon insert lock nuts come with each bolt, so the nuts are matched to the bolt.
U-bolts in this line come in square, round and semi-round end shapes, in many sizes, with lengths from 1.75 to 19 inches. Confirm the thread and bend of the bolt being replaced, since those decide whether SKY916X318X1312 is the right size.
Key features
- E-coated finish
- Sold as a single
- Nylon insert lock nuts supplied
- Replacement U-bolt for spring and axle work
Before the first drive
Most of the work on a U-bolt is done before the first drive. Confirm the bolt sits flat on the spring, that both legs go through the plate at the same depth, and that nothing blocks the bend. Check that the nuts start by hand without cross-threading, because a bolt that sits crooked will load one side harder than the other.
After the first few drives, check the nuts again. New threads and seating surfaces settle, so a nut that was snug can loosen slightly. Clean any grit from the plate, retighten evenly across both nuts, and recheck after the next service stop.
- Check the bolt sits flat on the spring
- Confirm both legs seat at equal depth
- Retighten nuts after early drives
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | SKY916X318X1312 |
| Product type | U-bolt |
| Finish | E-coated |
| Included hardware | 2 nylon insert lock nuts |
| Sold as | Single |
Vehicle fitment
It carries a universal fit label, but a U-bolt must suit a particular spring and axle. Check the diameter, thread and bend against your current bolt before buying.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Measure the old bolt before installation, fit the nylon insert lock nuts that come with SKY916X318X1312, and tighten evenly to the torque value for your vehicle.
What’s included
One SKY916X318X1312 U-bolt and two nylon insert lock nuts.









