Overview
The Skyjacker TR49S is a rear Softride leaf spring for the 1989–1995 Toyota Pickup (DLX and SR5) and the 1995–1997 Toyota Tacoma (Base and SR5). Each unit is one single spring.
The spring uses a progressive multileaf pack made from American steel, and the company puts its load capacity at or above OE levels. It is rated for a 0 to 4.99 inch lift height range and is a direct fit. Bushings are not included, and Skyjacker names SKYSE39T as the recommended bushing.
Key features
- Progressive multileaf pack
- American steel construction
- Load capacity at or above OE levels
- Lift height range 0 to 4.99 inches
- Direct fit for the listed Pickup and Tacoma trims
- Limited lifetime warranty
Bushings and alignment after install
Bushings sit at the spring eyes and carry the movement of the leaf as the axle travels. When they are not installed with the spring, the mounts can bind or rattle, so the bushing set should be ready and fitted before the new spring is bolted in place. Old bushings that have softened or split should be replaced rather than reused, since they will not hold the new spring’s position.
A rear spring change shifts ride height and the angle of the axle, which in turn affects the driveline and tire wear. Plan a check of the alignment and driveline angles after the work is complete, then recheck the spring hardware once the vehicle has been driven a short distance. Note any new noises during the first few trips so they can be traced early.
- Set aside bushings before the spring arrives
- Replace split or hardened bushings
- Check driveshaft angle after the lift
- Re-torque the spring hardware after a short drive
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | TR49S |
| UPC | 803696164175 |
| Position | Rear |
| Spring quantity | Single spring |
| Bushings | Not included |
| Recommended bushing | SKYSE39T |
| Construction | Progressive multileaf pack |
| Material | American steel |
| Lift height range | 0 to 4.99 inches |
| Fitment type | Direct fit |
| Warranty | Limited lifetime |
Vehicle fitment
It is a direct fit for the 1989–1995 Toyota Pickup (DLX, SR5) and the 1995–1997 Toyota Tacoma (Base, SR5).
Fitment is limited to those Pickup and Tacoma trims. Other generations and models fall outside it, so compare your year, model and trim before ordering.
Installation notes
Bushings are not supplied with this spring, so set up the recommended SKYSE39T bushing before the spring goes on. Ride height and axle position both change with a new spring, so plan an alignment check when the install is complete.
What’s included
One rear leaf spring.
Not included: spring bushings. Skyjacker recommends part number SKYSE39T.




