Overview
The Skyjacker TR39S is a rear Softride leaf spring for the 1995–1997 Toyota Tacoma in the Base and SR5 trims. It is a single spring, so a pair needs a second unit.
The spring is a progressive multileaf pack made from American steel. Its load capacity is at least equal to OE. It is rated for a 0 to 4.99 inch lift height range and is a direct fit. Bushings are not included; the recommended bushing is part number SKYSE39T.
Key features
- Progressive multileaf pack construction
- Made with American steel
- Load capacity at or above OE
- Lift height range 0 to 4.99 inches
- Direct fit for the listed Tacoma trims
- Limited lifetime warranty
Rear spring setup tips
The rear leaves carry the axle load and set how the back of a Tacoma sits. A new spring changes that height and the way the axle is located, so it is worth checking the rear end after the first few drives. Spring eyes and shackles should move freely, without stiffness or play, and the axle should sit square under the frame once the work is complete.
Old rear springs often sag gradually, so a new unit can restore a level stance that was lost over time. Inspect the U-bolts, spring perch and axle pad before fitting, because loose or worn clamps can allow the spring to shift under load and make the ride noisy. Clean the mating surfaces so the spring seats evenly against the axle.
- Check U-bolts for stretching or rust
- Inspect the axle pad and spring perch
- Recheck clamp torque after a short drive
- Schedule an alignment check after installation
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | TR39S |
| UPC | 803696164137 |
| Position | Rear |
| Spring quantity | Single spring |
| Bushings | Not included |
| Recommended bushing | SKYSE39T |
| Construction | Progressive multileaf pack |
| Material | American steel |
| Lift height range | 0 to 4.99 inches |
| Fitment type | Direct fit |
| Warranty | Limited lifetime |
Vehicle fitment
It is a direct fit for the 1995–1997 Toyota Tacoma in the Base and SR5 trims.
Fitment covers the 1995–1997 Toyota Tacoma in Base and SR5 trims only. Other years, generations and models fall outside that range, so check year, model and trim before ordering.
Installation notes
The recommended SKYSE39T bushing is not part of this kit, so have it ready before fitting the spring. Swapping springs changes ride height and axle position, so schedule an alignment check when the job is done.
What’s included
One rear leaf spring.
Not included: spring bushings. Skyjacker recommends part number SKYSE39T.




