Overview
The Skyjacker CR35S is a Softride rear leaf spring for 1988 to 2000 Chevrolet and GMC K1500, K2500 and K3500 trucks, with a 5 to 6.99 inch lift rating and rubber bushings already fitted.
The load rating is at or above the original equipment figure, and the steel is American. A Limited Lifetime Warranty applies to the spring.
Key features
- Progressive multileaf pack design
- Single rear spring per part number
- Pre-installed rubber bushings
- Lift height range 5 to 6.99 inches
- American steel construction
Heavy-duty rear spring care
Heavier-duty K2500 and K3500 trucks put more sustained load on the rear springs, especially when they tow or carry a bed full of cargo. Over time the leaves can take a set, which shows up as a lower rear end and a harsher ride. Checking the spring eyes, the bushings and the spring hangers during routine service helps catch that wear before it affects handling.
Because a lift range starts at 5 inches, the spring’s height change should be weighed against the tires, bumpstops and brake lines already on the truck. Keep the old and new parts organized during the job, and recheck the U-bolts once the truck has been driven a short distance.
- Look for leaves that rub against each other
- Check U-bolt torque after the first drives
- Inspect spring eyes for cracks
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | CR35S |
| UPC | 803696121550 |
| Product line | Softride leaf spring |
| Position | Rear |
| Spring quantity | Single spring |
| Bushings included | Rubber bushings included |
| Lift height range | 5 to 6.99 inches |
| Fitment | Direct fit |
| Material | American steel |
| Warranty | Limited lifetime |
Vehicle fitment
The manufacturer list covers 1988 to 1998 Chevrolet K1500, K2500 and K3500 trucks, 1988 to 1991 Chevrolet V30 and V3500 trucks, 1998 GMC C3500, 1988 to 1998 GMC K1500 and K3500, 1988 to 2000 GMC K2500 and 1988 to 1991 GMC V3500 trucks.
Trucks from before 1988 are not covered by this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The rubber bushings are already fitted, so a separate bushing kit is not needed. Because the lift range starts at 5 inches, schedule a wheel alignment and a driveline angle check after the swap. Chock the wheels and support the axle on stands before disconnecting the old spring.
What’s included
One rear leaf spring with pre-installed rubber bushings.
Not included: a second spring for the opposite rear side.





