Overview
The Rubicon Express Control Arm Bracket (part number RE9991) is a passenger side front lower control arm bracket for mounting a custom axle in a Jeep Wrangler TJ, which is the 1997–2006 Jeep Wrangler (TJ). It is bare steel and needs welding.
The bracket is laser cut from 3/16 inch cold rolled steel and then CNC formed for precision and strength. It is used for cleanly mounting a custom axle in a TJ, so it is a fabrication part rather than a bolt-on kit.
Key features
- Passenger side front lower control arm mount
- Laser cut from 3/16 in. cold rolled steel
- CNC formed for precision and strength.
- Bare steel with welding required
- Designed for a custom axle in a TJ
Welding a custom axle mount
A custom axle mount carries loads from the axle and control arm into the frame, so the weld quality matters as much as the fit. Because this bracket is bare steel, the welds should be clean and fully penetrated, and the surrounding metal should be free of paint and rust before welding. Fit the bracket before welding so the axle geometry can be checked.
After welding, the bare steel needs a protective finish to resist corrosion, especially around the weld beads. Inspect the welds and mounting points periodically for cracks, particularly after rough trail use. Keep the control arm pivots and the axle mounting hardware in good order, since they carry the same loads.
- Clean the frame and bracket surfaces before welding
- Check axle alignment before final welds
- Inspect welds for cracks after rough trail use
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE9991 |
| UPC | 614901442526 |
| Position | Passenger side, front lower control arm |
| Material | Cold rolled steel, 3/16 in. thick |
| Finish | Bare steel |
| Installation | Welding required |
Vehicle fitment
The bracket is for mounting a custom axle in a TJ, which is the 1997–2006 Jeep Wrangler (TJ).
This bracket is set up for the TJ mounting arrangement. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required, and the bare steel needs a protective finish after the welds are made, so the bracket does not rust at the weld areas.
Fit the bracket and check its position against the axle and control arm before welding.
What’s included
Not included: the custom axle and control arms the bracket mounts to.




