Overview
The Rubicon Express RE9976 is a passenger side rear upper control arm bracket, sold as a single bracket in bare steel. It is laser cut from 3/16 inch cold rolled steel and then CNC formed. It is made for mounting a custom axle in a TJ, and welding is required for installation.
This bracket is for the 1997-2006 Jeep Wrangler (TJ) in the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims. It is a direct-fit control arm mount and accepts any tube diameter.
Key features
- Passenger side rear upper control arm mount
- Bare steel, welding required
- Laser cut from 3/16 inch cold rolled steel
- CNC formed
- Sold as a single bracket
- Accepts any tube diameter
Welding and mounting prep
A bare steel bracket is only as good as its weld and the surface it sits on. Clean the bracket and the frame area down to bare metal, and make sure the bracket sits square against the mounting area before tacking it. Check that the weld penetration covers the full joint, since a cold or partial weld can crack under axle loads.
After welding, let the bracket cool and check the control arm angle at ride height and at full suspension travel. Look for clearance to the tire, the frame and nearby brake lines. A custom axle changes the arm geometry, so re-check the position after the first few drives and touch up any weld that shows cracking.
- Clean mounting surfaces to bare metal
- Tack and check square before final welding
- Check control arm angle at ride height
- Inspect welds after the first drives
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE9976 |
| UPC | 614901442410 |
| Position | Rear upper, passenger side |
| Type | Control arm mount |
| Material | 3/16 inch cold rolled steel |
| Finish | Bare steel |
| Sold as | Single |
Vehicle fitment
It is for the 1997-2006 Jeep Wrangler (TJ) in the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
Other Wrangler generations are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the bracket is bare steel, it has to be welded in place, so the install needs a welder and clean mounting surfaces. Check the control arm angle and the clearance at full suspension travel after the bracket is welded.
What’s included
One passenger side rear upper control arm bracket in bare steel, and welding is required for installation.



