Overview
The Rough Country 19401A is a forged upper control arm for GM trucks and SUVs from 2007 to 2016, including the Chevrolet Tahoe, Silverado 1500 and GMC Sierra, Yukon and Yukon XL. It is a solid, one-piece forged steel arm built without welded joints.
The arm uses POM ball joints for a greater range of motion and more wheel articulation than standard or OE replacements. The joints are fully greaseable and have a maintenance free design.
The arm also uses Clevite OE style rubber bushings. Its forged, one-piece construction has no welded joints that could bend or break under load.
Key features
- One-piece forged steel construction with no welds
- POM ball joints with a low-friction ball race
- Larger ball diameter for range of motion
- Fully greaseable ball joints
- Clevite OE style rubber bushings
Upper arms and lift geometry
Upper control arms work with the lower arms to set the wheel angle and keep the axle located. On a lifted truck the geometry changes, so the upper arm’s ball joint sees a different angle than it did at stock height. A forged one-piece arm has no welded joints, so it is built around a single piece of steel.
Ball joint angles and bushing wear matter most after a lift. Check the joints for play at each service, grease the fittings, and inspect the rubber for cracks. Have the front alignment checked once the lift and arms are in place, because upper arm changes shift caster and camber.
- Check the ball joint boot for tears
- Keep grease fittings clean before greasing
- Confirm brake line and steering clearance after installation
Specifications
| Brand | Rough Country |
|---|---|
| Part number | 19401A |
| Position | Front upper |
| Construction | Forged, one piece |
| Joint design | POM ball joint, fully greaseable |
| Bushings | Clevite OE style rubber |
| Lift requirement | 2.5 to 3.5 inch or 7 inch suspension lift |
Vehicle fitment
It fits the 2007–2016 Chevrolet Tahoe, the 2007–2016 GMC Sierra 1500, the 2007–2016 GMC Yukon, the 2015–2016 GMC Yukon XL and the 2007–2014 GMC Yukon XL 1500. The 2007 Chevrolet Silverado 1500 Classic with the old body style is excluded, so confirm your model before ordering.
It is for vehicles with a 2.5 to 3.5 inch or 7 inch suspension lift. Models with a 5 to 6 inch lift, stock height models, and models with factory stamped steel knuckles and control arms are outside its fit. Confirm your vehicle’s year, model, lift height and trim before ordering.
Installation notes
This arm is for vehicles with a suspension lift in the stated range, and it is not for stock height trucks. Have the front alignment checked after installation.
What’s included
One forged upper control arm with POM ball joints and Clevite OE style rubber bushings.












