Overview
The Rough Country 3-to-3.5-inch Jeep Gladiator suspension lift kit, part number R/C63730, fits the 2020–2026 Jeep Gladiator. It gives enough ground clearance for tires up to 37 inches and a more commanding look, and it keeps the factory coil springs in service.
The kit uses front and rear coil spacers, which let the owner keep the factory coil springs. It also includes N3 nitrogen-charged shocks, with 10-stage variable valving, an 18mm spring-loaded piston rod and a 54mm shock body. The shocks have reinforced seals.
Coil spacers raise the body by sitting between the factory coil springs and their seats, so the existing coils stay in service. The 10-stage valving lets the shock be tuned across a wider range of compression and rebound, which the brand links to on- and off-road use.
Clearance for 37-inch tires depends on wheel offset and backspacing as well as lift height, so the brand’s tire figure should be checked against the wheels on the truck.
Key features
- Front and rear coil spacers that keep the factory coil springs
- N3 nitrogen-charged shocks at the front and rear
- 10-stage variable valving
- 18mm spring-loaded piston rod and 54mm shock body
- 100% bolt-on installation
- Clearance for up to 37-inch tires
Spacers versus coil swaps
A coil spacer lift keeps the factory springs, which is a different approach from a full coil swap. Because the existing coils stay in place, the spring rate does not change, so payload and ride feel stay close to stock. The trade-off is that the added height is set by the spacer length, and shock travel should be checked against the new ride height.
With the factory coils retained, the shocks carry the new height. Shocks with 10-stage valving can be set across a wider range of compression and rebound, but dampers still wear with age and mileage. Check the upper and lower mounts, the shock bodies and the bump stops during regular inspections, since spacers do not correct worn parts.
- Measure coil compression with the truck at ride height
- Inspect spring seats for cracks
- Check shock travel at full droop
Specifications
| Brand | Rough Country |
|---|---|
| Part number | R/C63730 |
| Lift kit | 3 to 3.5 inches |
| Shock series | N3, nitrogen-charged |
| Shock valving | 10-stage variable |
| Piston rod | 18mm spring-loaded |
| Shock body | 54mm |
| Rear lift component | Spacer |
| Tire size | 37 inches |
| Lift height range | 0 to 3.5 inches |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2020–2026 Jeep Gladiator, including the High Altitude, Launch Edition, Mojave, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport versions.
Gladiator years before 2020 and Wrangler (JL) models are not on the list.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit is designed for a bolt-on installation without cutting. After installing a lift of this height, have the alignment checked and the driveline angles reviewed.
What’s included
Front and rear coil spacers and N3 front and rear shocks, with hardware for installation.












