Overview
The RockJock 4×4 CE-91107 is a 9/16 inch greasable bolt with hardware, part number R/JCE-91107, used in 2 1/2″ Johnny Joints. It has 9/16″ fine thread and a zerk fitting installed in its head.
The greasable head lets you lubricate the joint through the zerk after assembly. The kit adds two flat washers and a crush nut, so the bolt can be used with the joint as a complete set.
Key features
- 9/16″ fine thread
- Greasable head with a zerk fitting installed
- Two flat washers included
- Crush nut included
- Used in 2 1/2″ Johnny Joints
Keeping the joint serviced
A greasable bolt only helps if the grease reaches the joint’s bearing surfaces. After assembly, pump slowly through the head zerk until fresh grease appears at the seal. Clean the zerk tip before each session so dirt does not get pushed into the bore.
Crush nuts behave differently from locking nuts. Once a crush nut is tightened, it deforms to hold its position, so it is best used once and replaced if removed. Check the washer faces for flattening or galling before fitting them, and keep the thread clean so the nut seats squarely against the joint.
After trail runs, look over the bolt head and washers for cracks or movement. A loose bolt lets the joint shift in its bore and wear the housing faster. If the zerk is damaged, replace it before the joint runs dry, since dry bearing surfaces wear quickly under articulation.
- Clean the zerk before every grease session
- Replace a crush nut once it has been removed
- Check washers for flattening or galling
- Inspect the bolt head after trail runs
Specifications
| Brand | RockJock 4×4 |
|---|---|
| Part number | R/JCE-91107 |
| Thread | 9/16″ fine |
| Lubrication | Zerk fitting in head |
| Hardware included | 2 flat washers, 1 crush nut |
| Used in | 2 1/2″ Johnny Joints |
Vehicle fitment
This bolt is universal fit, so it is not tied to one vehicle. Whether it suits depends on the 9/16 inch fine thread and the 2 1/2 inch Johnny Joint it goes into.
Check the thread size against your joint before installing.
Installation notes
The zerk is already installed in the bolt head, so grease the joint through it after assembly.
What’s included
Greasable bolt with a zerk fitting in the head, two flat washers and a crush nut.









