Overview
The Rigid Industries 30-inch E/SR-Series Roof Mount (part number 46532) holds a 30-inch E-Series or 30-inch SR-Series light bar on the roof of a Polaris RZR XP 1000. It fits the 2014-2016 Polaris RZR XP 1000 in its EPS versions. The mount is made of 100% stainless steel and bolts in place.
The mount works only with the factory cage. With a 30-inch E-Series or SR-Series bar, it supports up to 15640 raw lumens, making it a lighting option for off-road use on an RZR.
The mount has a black powder coat finish and is made in the USA. It carries a limited lifetime warranty.
Key features
- 100% stainless steel construction
- Black powder coat finish
- Bolt-in design for the factory cage
- Holds a 30-inch E-Series or 30-inch SR-Series light bar
- Includes all necessary hardware
- Made in the USA
Wiring and aiming a roof light
A roof-mounted light bar sees constant vibration, so the bolts and the bar’s mounting points deserve regular attention. Use a fused, properly rated circuit for the bar and route the wiring so it stays clear of moving parts and sharp edges. A switch placed where you can reach it while driving makes it easier to turn the light off when oncoming traffic needs room.
Aim the bar with the vehicle parked on level ground, then check the aim again after rough trails, since a small shift changes the beam pattern a lot. Stainless steel resists corrosion well, but the powder coat on the mount can chip, so touch up exposed areas to keep the finish intact.
- Use a fused, properly rated circuit
- Route wiring away from moving parts
- Aim the bar on level ground
- Touch up chips in the powder coat
Specifications
| Brand | Rigid Industries |
|---|---|
| Part number | 46532 |
| Bar size | 30-inch E-Series or 30-inch SR-Series |
| Material | 100% stainless steel |
| Finish | Black powder coat |
| Mounting | Bolt-in, factory cage only |
| Light output supported | Up to 15640 raw lumens |
| Warranty | Limited lifetime |
| Made in | USA |
Vehicle fitment
It fits the 2014-2016 Polaris RZR XP 1000. Other RZR models and model years are not covered, and the mount works only with the factory cage, so confirm your roof has that cage before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
These are bolt-in mounts that use the factory cage, so no drilling is described. Use the hardware included with the mount.
What’s included
The roof mount, part number 46532, with all necessary hardware.
Not included: the 30-inch E-Series or SR-Series light bar. The lights are sold separately.









