Overview
The light bar bracket kit, part number ASI101005MC09011, mounts a light bar to a roll cage. It includes two steel brackets, four aluminum clamps and two laser cut aluminum logo plates. The kit began as the mounting hardware used on vehicles built in house and was later refined into this version.
Fit depends on the roll cage and the light bar rather than a make or model. Measure the cage at the top before choosing a bar. The kit is designed to suit most setups when the right light bar is selected.
The brackets are made from high-grade steel, bent and powder coated black. The clamps are lightweight aluminum, and the logo plates are laser cut from raw aluminum.
Key features
- Steel brackets, bent and powder coated black
- Aluminum clamps for securing the bar to the cage
- Laser cut raw aluminum logo plates
- Reversible brackets that move the mount about 1/2 inch in either direction
- Bends at the cage mounting points add roughly 1/2 inch of inset or offset
- Installation hardware included
Cage measurement and bar choice
Light bars add weight high on a roll cage, so the cage needs to be sound and braced at the mounting points before a bar is added. Look for dents, cracks and rust at the tubing where clamps will sit. A bar that is too heavy for the cage tubing can flex the structure and loosen fasteners on rough ground.
Plan the wiring before mounting. Route harnesses away from moving parts and sharp edges, and use a relay and fused circuit that suit the bar’s draw. Aim the bar after it is tight and recheck the aim after the first few rides. Aluminum clamps can dull or scratch cage paint, so protective tape where they contact the tube helps reduce wear.
- Inspect cage tubing for dents and rust
- Route wiring away from moving parts
- Recheck aim and fasteners after the first rides
- Use protective tape where clamps contact paint
Specifications
| Brand | Assault Industries |
|---|---|
| Part number | ASI101005MC09011 |
| Product type | Light bar bracket kit |
| Bracket material | High-grade steel, powder coated black |
| Clamp material | Lightweight aluminum |
| Logo plates | Laser cut raw aluminum |
| Offset compensation | Roughly 1/2 inch, from the bends and the reversible brackets |
| Package contents | Two brackets, four clamps, two logo plates, installation hardware |
Vehicle fitment
Fit depends on the roll cage and the light bar. Measure your cage at the top to confirm the bar fits the mounting points.
Assault Industries names these light bars as confirmed to work: KC Hilites Flex, C-Series and Gravity 39 to 40-inch bars; Rigid E-Series, Radiance, curved and SR-Series Pro 40-inch bars; Baja Designs S8 40-inch; and Vision X XPL 40-inch.
Installation notes
Measure the cage at the top to determine the light bar size that will fit. Spacers may be needed. If only one or two washers are needed on either side, add washers. If more are needed, swap the brackets around, since they are reversible and move the mount about half an inch.
Remove the logo plates before reversing the brackets, then remount them. Use the installation hardware included with the kit.
What’s included
Two brackets, four clamps, two logo plates and installation hardware.
Not included: the light bar. The kit is built to hold a light bar, and the bar must be chosen separately.












