Overview
The Revtek REV430 is a 3-inch lift system for the 1996 to 2002 Toyota 4Runner. It works on 2WD and 4WD 4Runners with manual or automatic hubs and covers the Base, Limited and SR5 versions. The lift height range is 0 to 3.5 inches, and it is a direct fit.
The components are designed to OEM or better quality. The system reduces front end dive and body roll, and it does not require replacement shocks. Check the parts in the box against part number REV430 before installing.
Key features
- 3-inch lift for the 1996 to 2002 4Runner
- Works on 2WD and 4WD models
- Works with manual or automatic hubs
- Reduces front end dive and body roll.
- Does not require replacement shocks
- Lift height range of 0 to 3.5 inches
Choosing a lift height
A lift raises the body relative to the axles, which changes the angles of the driveshafts and the steering linkage. On a 4Runner, a modest height increase like this one mainly affects how the truck sits on the road and how the front suspension responds to dive under braking. Lift height is a trade-off. Higher lifts usually need more driveline correction and more attention to brake lines and cables, so a smaller increase is often easier to live with for daily use.
Before choosing a lift, look at how the truck is used. Trail work benefits from extra ground clearance, while highway driving benefits from stable alignment and predictable steering. Check the bump stops, the brake hose length and the speedometer calibration after the new height is set, because these items are commonly affected when a suspension is raised.
- Check brake hose length after the lift
- Re-torque suspension fasteners after the first trail runs
- Recheck alignment after any change in tire size
- Inspect bump stops for contact at full compression
Specifications
| Brand | Revtek |
|---|---|
| Part number | REV430 |
| Lift size | 3 inches |
| Lift height range | 0 to 3.5 inches |
| Drive type | 2WD and 4WD |
| Hubs | Manual or automatic |
| Replacement shocks | Not required |
| Fitment type | Direct fit |
Vehicle fitment
This kit fits 1996 to 2002 Toyota 4Runner models in the Base, Limited and SR5 versions.
The 2003 and later 4Runner is not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
A 3-inch lift changes suspension geometry, so plan on a wheel alignment and a driveline angle check after installation.
What’s included
Check the package contents against part number REV430 before starting the installation.





