Overview
The Rancho RS999332 is a rear RS9000XL Series shock absorber for 2007–2018 Jeep Wrangler (JK) models with a 4 inch rear lift. Rancho specifies use with its RS6509B long arm, which makes this shock a component of a rear lift setup rather than a stand-alone bolt-in upgrade.
The shock is nitrogen gas charged and uses an 18mm piston rod. A 9-position tuner, manual or remote, adjusts the damping so the rear end can be set for road comfort or for firmer off-road control. A protective boot is included.
Key features
- Rear position for a 4 inch lift
- Designed for use with the Rancho long arm RS6509B
- 18mm diameter piston rod
- 9-position manual or remote tuning
- Nitrogen gas charged, gas charged hydraulic design
- Protective boot included
Long arm and rear lift geometry
A long arm changes the angle and length of the rear control geometry, so the shock has to match that new position. When the arm and shock are used as a matched set, the travel, damping and mounting angles are designed to work together. Mixing parts from different setups can leave the shock too short, too long or set at an odd angle under load.
Before installing, measure the shock’s extended and compressed lengths against the new arm angle, and check the brake lines and driveshaft for clearance. Re-check every bolt after the first few trail runs and inspect the boots and bushings at regular service intervals. Tuning is easiest to judge after the vehicle is back on its wheels and at full ride height.
Specifications
| Brand | Rancho |
|---|---|
| Part number | RS999332 |
| Shock series | RS9000XL Series |
| Position | Rear |
| Lift height | 4 inch (feature list); 3.5 in. (lift field) |
| Piston rod diameter | 18mm |
| Tuning | 9-position manual or remote |
| Charge | Nitrogen gas charged |
| Fitment type | Direct fit |
| Included | Protective boot |
Vehicle fitment
The shock fits 2007–2018 Jeep Wrangler (JK) models, including Rubicon, Sahara and Unlimited trims, along with the other covered trims.
Other Jeep models and years are not covered by this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The feature list gives a 4 inch lift while the lift field reads 3.5 in. Confirm which figure matches your rear suspension and long arm setup before installing.
What’s included
A rear RS9000XL shock absorber with protective boot included.
Not included: the Rancho RS6509B long arm that this shock is used with.














