Overview
The Rancho RS5040 is a rear gas-charged shock absorber from the RS5000 Series. It fits the 2000–2006 Toyota Tundra in Base, Limited and SR5 trims, with a lift rating of w/0 in. Lift/Drop.
This RS5000 Series unit suits light trucks and sport utility vehicles used on road and off road, with fitment for both stock and raised trucks. It uses ten-stage velocity sensitive valving with a 1 3/8-in. (35mm) piston.
Key features
- Rear position, gas-charged design
- Ten-stage velocity sensitive valving
- 5/8-in. (16mm) diameter piston rod
- 1 3/8-in. (35mm) diameter piston
- Red protective boot included
Tundra rear shock replacement tips
Rear shocks on a Tundra work hardest when the truck carries cargo or towing loads, and they shape how the back end settles after a bump. A gas-charged body helps the damper hold steady under repeated strokes, which matters on washboard and rough trail. Tundra owners often notice a change in body motion when the old shock has lost its control, so comparing ride behavior before and after the swap is a useful check.
Replacing a rear shock is a good moment to inspect the upper and lower mounts, rubber bushings and the bump stops. Tighten mounting hardware to the vehicle’s specification once the truck is on the ground, and re-check the bolts after the first few drives. If the new shock is installed with the suspension sagging, the travel and damping will not match the design.
- Check upper and lower mounts
- Inspect rubber bushings and bump stops
- Re-check hardware after the first drives
Specifications
| Brand | Rancho |
|---|---|
| Part number | RS5040 |
| UPC | 10039703504000 |
| Series | RS5000 Series |
| Position | Rear |
| Charge | Gas charged |
| Valving | Ten-stage, velocity sensitive |
| Piston rod diameter | 5/8 in. (16 mm) |
| Piston diameter | 1 3/8 in. (35 mm) |
| Lift rating | w/0 in. Lift/Drop |
| Fitment type | Direct fit |
| Warranty | Limited lifetime (Rancho) |
| Quantity | Each |
Vehicle fitment
The RS5040 fits the 2000–2006 Toyota Tundra in Base, Limited and SR5 trims.
Tundra models from 2007 onward and other trims are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The lift rating is w/0 in. Lift/Drop, so compare it with your Tundra’s current height before fitting. The RS5040 is a direct-fit rear shock and takes the place of the original rear shock.
What’s included
Supplied: one RS5040 rear shock with the red protective boot included.









