Overview
The Rancho RS44192 is a 2.5 inch rear leaf spring for the Jeep CJ5, CJ7 and Scrambler. It is sold as a single spring, and two are required per vehicle.
A leaf spring stacks flat steel leaves to carry axle load and locate the axle under the body. This spring is preset to reduce settling, has leaf ends trimmed to reduce friction and improve stress distribution, and has individual leaves shot-peened to reduce stress and improve fatigue life.
Rubber bushings are included, and the spring is covered by a limited lifetime warranty. Its lift height range is 0 to 4.99 inches, and this spring provides a 2.5 inch lift at the rear.
Key features
- 2.5 inch lift at the rear
- Preset springs to reduce settling
- Trimmed leaf ends to reduce friction
- Shot-peened individual leaves for fatigue life
- Rubber bushings included
- Limited lifetime warranty from Rancho
Rear axle and driveline checks
A 2.5 inch rear lift changes the angle of the driveshaft and pinion, which can raise vibration at speed. Check the pinion angle and U-joint angles after installation, and correct them if the angles run too steep. Wear in the joints shows as a clunk or shudder when the throttle is applied.
Leaf springs also control axle position, so worn shackles and bushings can let the axle shift under braking and acceleration. Replace these parts when the springs are changed. Inspect the spring clips and U-bolts for looseness and retighten after the first few drives.
Off-road use puts extra stress on spring packs, especially when the leaves are twisted in ruts. Check for cracked leaves, broken spring eyes and rust at the leaf ends. Keep the rear springs and axle clean so corrosion does not hide developing damage.
- Check the pinion and U-joint angles after the lift
- Replace worn shackles and bushings with the springs
- Inspect U-bolts and spring clips after the first drives
Specifications
| Brand | Rancho |
|---|---|
| Part number | RS44192 |
| UPC | 39703441926 |
| Position | Rear |
| Lift | 2.5 inch |
| Lift height range (inches) | 0 to 4.99 |
| Spring quantity | Single spring, 2 required |
| Bushings | Rubber bushings included |
| Sold | Individually |
| Warranty | Limited lifetime, from Rancho |
Vehicle fitment
It fits these vehicles:
- 1976–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade)
- 1976–1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade)
- 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR)
It does not fit the Wrangler (YJ), the Cherokee, the Grand Cherokee or other Jeep models outside this range. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Two springs are required, so replace the rear springs as a pair. A 2.5 inch lift changes ride height and driveline angles, so check the driveline angles and have the alignment checked after installation. Support the vehicle securely on stands while the springs are removed.
What’s included
One rear leaf spring with rubber bushings.
Not included: the second rear spring, which is needed to complete the pair.








