Overview
The Pro Comp 69406 is a Pro Runner upper control arm fitted with an oversized stainless steel uniball joint. It replaces stock stamped steel arms whose ball joints are not built for off-road use. The arm is a full control arm, and no vehicle is named for it, so match it to your truck before ordering.
Key features
- Oversized stainless steel FK uniball joint
- Heavy-duty 1-inch chromoly tubing
- Reinforced pivot bushing mounts
- PTMEG pivot bushings
- Billet machined dust cap
- Black powder coat finish
Before you buy
Upper control arms carry steering and suspension loads at the top of the axle, so the mounts on the frame and the arm geometry have to line up with your truck. A replacement arm should locate the axle the same way the factory part did, or the alignment and tire wear will suffer.
Arm length, pivot position and joint type all affect how the suspension cycles. Compare these points with the arm you are removing. If a lift or other modification is already installed, check that the arm still clears the frame and the wheel at full travel.
Pivot bushings wear over time, so inspect them during each service. Keep the grease fittings serviced and check the dust cap for damage, since debris in the joint is a common cause of early wear.
- Confirm the mounting points match
- Check clearance at full suspension travel
- Inspect the bushings at each service
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 69406 |
| UPC | 614901141696 |
| Position | Upper control arm |
| Joint | Stainless steel FK uniball |
| Tube | 1-inch chromoly |
| Pivot bushings | PTMEG with zerk fittings |
| Finish | Black powder coat |
| Fitment type | Universal listed |
The arm uses a billet machined dust cap to keep dirt and debris out of the uniball, and each arm is finished in black powder coat for lasting performance.
Vehicle fitment
No vehicle is named for this arm. Confirm the mounting points and ball joint layout against your truck before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the arm changes the front suspension geometry, the alignment should be checked after installation. The pivot bushings take grease through the zerk fittings.
What’s included
The arm ships with its uniball joint and billet dust cap. Compare the contents with your installation plan before starting the job.






