Overview
The Pro Comp Suspension 50328 is a U-bolt kit that comes with new hi-nuts and extra thick washers. Low-alloy high-strength steel gives it Grade 5 equivalent strength.
Key features
- New hi-nuts
- Extra thick washers
- Low-alloy high-strength steel
- Grade 5 equivalent
Corrosion and finish
The finish on a U-bolt kit is there to slow rust, and the two styles handle it differently. Round U-bolts carry a zinc coating, while square U-bolts are left bare. Over time the zinc can wear at contact points, and the bare steel will show surface rust sooner in wet or salty conditions. Neither condition alone means the part has failed, but both are worth watching during inspections.
Clean off light rust with a wire brush and a light coat of protective spray where the finish is missing. Avoid damaging the zinc during fitting, and keep the nuts clear of mud and grit so they turn freely. Deep pitting, flaking that exposes bright metal across a bend, or thread damage calls for replacing the U-bolt.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 50328 |
| UPC | 614901109337 |
| Material | Low-alloy high-strength steel |
| Strength | Grade 5 equivalent |
| Round U-bolts | Zinc plated |
| Square U-bolts | Unplated |
| Fitment type | Direct fit |
Vehicle fitment
Check the U-bolt length against your axle and spring pack before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Mark the nut positions after tightening so any loosening after the first drives is easy to spot, and check the clamp again at regular service intervals.
What’s included
U-bolts with new hi-nuts and extra thick washers.





