Overview
The Pro Comp EXP217510B is a single PRO-X twin tube steering stabilizer for the 1975–1983 Jeep CJ5, CJ7, Cherokee (SJ), Wagoneer (SJ) and a range of other Jeep models from the same years. The stabilizer has a 17.5-inch extended length and a 6.77-inch travel length.
A steering stabilizer is a hydraulic damper between the axle and the steering linkage, limiting wheel vibration and bump steer. The PRO-X twin tube design provides damping suited to a range of road conditions.
The piston is a 1-3/8 inch nylon banded piston on a 5/8 inch chrome hardened shaft. A Teflon rebound stop is fitted to the unit.
Key features
- PRO-X twin tube design with a 1-3/8 inch nylon banded piston
- 5/8 inch chrome hardened shaft
- Teflon rebound stop fitted to the unit
- Black powder coat finish
- Stem upper mount and loop lower mount
Before you buy
Stem and loop mounts are the main compatibility question with this kind of stabilizer. A stem end needs a matching bracket with a suitable hole and fastener, and a loop end needs a bracket that fits through the eye. Measure the mounting spots on the axle and steering linkage before selecting brackets, so the stabilizer can extend and collapse without binding.
A shock boot is a separate item for a unit that sees trail dirt. It keeps grit off the exposed shaft and helps the seal last longer. Owners of older Jeeps often replace worn steering linkage parts at the same time, including tie rod ends and drag link bushings, since a stabilizer works best with tight steering components.
- Confirm bracket type for stem or loop mount
- Check the shaft for bends or scoring
- Plan for a shock boot if the unit will see mud or sand
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXP217510B |
| Series | PRO-X hydraulic steering stabilizer |
| Type | Stabilizer only, single |
| Extended length | 17.5 inches |
| Collapsed length | 10.73 inches |
| Travel length | 6.77 inches |
| Body diameter | 1.75 inches |
| Upper mount | Stem |
| Lower mount | Loop |
| Piston | 1-3/8 inch nylon banded |
| Shaft | 5/8 inch chrome hardened |
| Finish | Black powder coat |
| Brackets included | No |
| Shock boot included | No, sold separately |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1975–1983 Jeep Cherokee (SJ), the 1975–1983 Jeep CJ5 and the 1976–1983 Jeep CJ7, along with the 1975 CJ6, the 1975–1983 DJ5, J10 and J20, the 1981–1983 Scrambler and the 1975–1983 Wagoneer (SJ), each in its own trims.
The list is limited to these 1975–1983 Jeep models, so Wrangler and later Cherokee are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the stabilizer uses a stem upper mount and a loop lower mount, the brackets used on the vehicle need to match. Brackets are not included, so check the mounting points before ordering.
What’s included
The stabilizer is sold individually. Brackets and the optional shock boot are not included, and the shock boot is sold separately.
Not included: brackets and the shock boot.









