Overview
The Pro Comp PRO-X EXP219505B is a single hydraulic steering stabilizer for Jeep Wrangler LJ and TJ models. It has a 19.35 inch extended length, a 7.18 inch travel length and loop ends at both ends. It is sold individually, and the stabilizer does not include a shock boot or brackets.
The stabilizer is designed to improve handling and reduce wheel vibration, which can lead to suspension component fatigue and failure. It helps reduce bump steer from oversized tires or rough roads. Its construction follows the general-purpose twin tube design of the PRO-X shock line, with a Teflon rebound stop for a comfortable highway ride.
Key features
- Single hydraulic steering stabilizer
- Helps reduce bump steer from oversized tires and rough roads
- Teflon rebound stop
- 1-3/8 inch nylon banded piston
- 5/8 inch chrome hardened shaft
- Loop ends at both mounts, black powder coat finish
Before you buy
Loop-ended stabilizers depend on a matching bracket at each end, and the bracket design often determines whether the stabilizer clears the axle and steering arm. Before buying, look at how the existing mounts are shaped. If they are worn, bent or missing, replace them first, because a new stabilizer cannot control movement that flexes through a damaged bracket.
Travel length matters on a Wrangler because the stabilizer is pushed and pulled through the full range of steering and suspension movement. Check the stabilizer at both full left and full right lock with the tires on the ground to confirm it does not reach its limit or bind against nearby parts. A lift or larger tires change those clearances, so recheck the fit after any suspension change.
Stabilizers wear fastest where they meet road grit and water. Wipe the shaft clean after muddy runs, look for oil on the body and inspect the rubber or polyurethane bushings during routine service. Replacing a worn tie rod end or drag link at the same time keeps the steering geometry balanced.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXP219505B |
| Shock series | PRO-X |
| Type | Steering stabilizer only, single |
| Hydraulic | Yes |
| Extended length | 19.35 in |
| Collapsed length | 12.17 in |
| Travel length | 7.18 in |
| Body diameter | 2.36 in |
| Upper mount | Loop |
| Lower mount | Loop |
| Piston | 1-3/8 inch nylon banded |
| Piston rod | 5/8 inch chrome hardened |
| Finish | Black powder coat |
| Brackets | Not included |
| Shock boot | Not included, sold separately |
Vehicle fitment
It fits 2004–2006 Jeep Wrangler (LJ) Unlimited and Unlimited Rubicon models, and 1997–2006 Jeep Wrangler (TJ) models.
The list does not include the Wrangler YJ, JK or JL, or the Cherokee and Grand Cherokee. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Brackets are not included, so confirm that your steering components have loop-compatible mounts before ordering, or add brackets that match them. The travel length of 7.18 inches is a limit to check against your steering geometry once the stabilizer is mounted.
What’s included
One PRO-X steering stabilizer, sold individually.
Not included: mounting brackets and the optional shock boot, which is sold separately.








