Overview
The Pro Comp ZX2085 is a rear Pro Runner monotube shock absorber for the 2007–2010 Jeep Wrangler (JK) Unlimited. It is designed for vehicles with 0 to 2 inches of lift.
The shock is gas charged, with a nitrogen pressurized monotube body. The design resists cavitation during compression and rebound and dissipates heat more efficiently than a twin tube hydraulic shock. The valving is multi-stage and tuned to each vehicle, and the body is zinc plated and clear coated.
The ZX2085 is a rear shock designed for vehicles with 0 to 2 inches of lift on the 2007–2010 Jeep Wrangler JK Unlimited. Its monotube body keeps oil and nitrogen gas in one tube with a floating piston, which holds the oil under pressure during compression and reduces foaming on long descents.
Key features
- Rear position, direct fit
- Designed for 0 to 2 inch of lift
- Gas charged monotube, nitrogen pressurized
- Multi-stage valving tuned to the application
- Zinc plated, clear coated finish
Rear shock service on a Wrangler
The rear shocks on a Wrangler JK carry the body’s weight over bumps and control the axle’s movement on uneven ground. A gas charged monotube helps the shock keep its damping steady when it is worked hard, which matters on long descents and rough trails. The loop mounts at each end should be checked for wear before every trip where the shock is loaded.
When inspecting, look for oil streaks on the body, a cracked or flattened bushing and a torn boot. Worn rear shocks often show up as a bouncy ride or a body that keeps moving after a dip. If you replace one rear shock, check the other side as well so the ride stays even from left to right. Keep the boot clean, since grit can work into the shaft.
- Look for oil streaks on the body
- Inspect bushings and loop mounts
- Check boots for tears and grit
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | ZX2085 |
| UPC | 614901094923 |
| Shock series | Pro Runner |
| Position | Rear |
| Lift height | 0 to 2 in. |
| Body | Monotube, gas charged |
| Finish | Zinc plated, clear coated |
Vehicle fitment
It is a direct fit for the 2007–2010 Jeep Wrangler JK Unlimited, at 0 to 2 inches of lift.
The list covers the JK Unlimited only, so the two-door Wrangler JK and the 2011 and later JK years are not shown. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shock uses a loop mount at each end, so confirm that the rear shock mounts on your Wrangler are loop style before installation.
What’s included
One rear Pro Runner monotube shock with boot. Sold as each.


























