Overview
The Pro Comp CV style rear drive shaft 4040 is a two-piece steel driveshaft for the rear of a lifted vehicle. It is designed to work with Pro Comp slip yoke eliminator kits and is made for a 4 to 5 inch lift.
The shaft is a CV style design with a 17 inch collapsed length and a 21.5 inch extended length. It is for rear use only.
Key features
- CV style joints
- Two-piece steel construction
- 17 inch collapsed length and 21.5 inch extended length
- Designed for use with a Pro Comp slip yoke eliminator
- Rear position
Driveshaft length and joints
A driveshaft has to span the distance between the transmission or transfer case and the rear axle at every point of suspension travel. When the rear is lifted, the shaft angles change, and a CV joint handles those angle changes more smoothly than a conventional U-joint at higher angles. Measure the installed length with the truck at normal ride height and again at full droop before cutting or ordering, since length decides whether the fit is clean.
A slip yoke eliminator replaces the transmission’s slip yoke with a fixed connection, so the shaft no longer slides in and out. Because the front of the shaft is fixed, the pinion angle and transmission output angle need checking after installation. Inspect the CV joint boots for tears and grease loss, and listen for clicks during turns, which can signal joint wear.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 4040 |
| Joint style | CV |
| Construction | Two-piece steel |
| Collapsed length | 17 inches |
| Extended length | 21.5 inches |
| Lift | 4 to 5 inch |
| Position | Rear |
| Required part | Slip yoke eliminator |
| UPC | 614901694154 |
Vehicle fitment
This is a universal fit rear shaft. A driveshaft has to match the vehicle’s length and joints, so confirm both for your vehicle before ordering.
Installation notes
A slip yoke eliminator is required with this driveshaft, so order the eliminator kit along with the shaft. The 4 to 5 inch lift range is the setup this shaft is made for.
What’s included
One two-piece CV style rear drive shaft.
Not included: the slip yoke eliminator, which is required and sold separately.






