Overview
The Omix-ADA front drive shaft, part number 53005541, is a non-CV, stock-length replacement shaft. It is a direct factory fit replacement and suits a manual transmission.
Confirm the position against your existing shaft before installing this part, since front and rear shafts differ.
Key features
- Non-CV design
- Stock length
- Direct factory fit replacement
- Does not require a slip yoke eliminator
- Noted for manual transmission
When to replace a driveshaft
A driveshaft usually needs replacing after a visible bend, a cracked tube, or joints that have failed. Vibration that rises with road speed, clunking when the transmission changes load, or a shaft that rotates unevenly are also signs of trouble. Before replacing the shaft, check the joints and the yokes, since a worn joint can damage a new shaft quickly.
A non-CV, stock-length shaft is simpler than a CV design, so the joints are the main wear points to inspect. Look for grease leaks, play at each end, and rust around the yokes. Balance matters too, so a shaft that has been dented or repaired should be checked before it is returned to service.
- Check for bends and cracked tubes
- Inspect joints for play and grease leaks
- Check yokes for rust
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 53005541 |
| UPC | 804314096588 |
| CV type | Non-CV |
| Length | Stock |
| Position | Front |
| Slip yoke eliminator | Not required |
| Transmission | Manual |
Vehicle fitment
No vehicle years, makes or models are named, so vehicle fitment is not confirmed.
Match the shaft to your existing driveshaft’s position and transmission before choosing it. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
It does not require a slip yoke eliminator. Confirm the position against your existing shaft before fitting it.
What’s included
No accessories or extra hardware come with the shaft.













